General Electric Dishwasher Parts

Dishwasher won't power on or cycles won't start? This control board manages cycle selection and timing. Intermediate repair, 30-45 minutes typical.

Drain hose assembly that connects your dishwasher pump to the drain system. Replace if cracked, leaking, kinked, or disconnected from the pump fitting.

Finished access panel for dishwasher front. Replaces cracked, rusted, or damaged panels. Restores clean appearance and protects internal components.

Replaces cracked, dented, rusted, or split dishwasher front panel. Restores appearance and provides secure mounting for controls and components.

Replace your dishwasher's control knob if it's cracked, broken, missing, or worn. This knob installs on the front control panel to operate cycle settings.

Restores manual timer control on your dishwasher. Push-on replacement knob for setting cycle durations when the original is cracked, worn, or missing.

Secures control or selector knobs on your dishwasher. Replace if the latch is broken, cracked, or missing, causing knobs to slip or pop off the panel.

This harness jump is a short jumper wire assembly used to reconnect two electrical terminals, restoring an intended circuit path for proper operation. It offers a direct, serviceable way to replace a broken or missing factory jumper. What it does:

• Bridges two terminals to complete a circuit when the original jumper is damaged or removed
• Helps restore power or signal to control components that rely on the jumper connection
• Commonly used in control, terminal block, or switch assemblies where a short wire link is required
• Can resolve symptoms such as intermittent or no power to a circuit, or a component not receiving a control signal

• One harness jump (single jumper wire assembly)

• High-level replacement only; ensure power is disconnected at the breaker or unplug the appliance before servicing
• Match connector style and terminal orientation to the original jumper before installing
• Inspect surrounding wiring and terminals for damage or corrosion; replace if needed

Upper venturi assembly for dishwasher spray arm system. Connects water supply to upper spray arm. Replace if cracked, broken, or leaking to restore spray.

Dishwasher bag hugger assembly installs on upper rack to secure lightweight items during wash cycles. Replace if broken, cracked, or missing.

Lower dishrack assembly for dishwasher bottom level. Holds plates, pots, and pans during wash cycles. Replace if rusted, cracked, or tines broken.

Secures the sump seal and housing to prevent leaks in your dishwasher. Replace if corroded or loose. Twists to lock in place. Verify fit with model.