General Electric Dishwasher Parts

Dishwasher dishrack finger indexer snaps onto the rack to help guide and position dishes during the wash cycle. Replace if broken, cracked, or missing.

This vent flapper is the exterior exhaust flap that opens to let dryer air and lint exit and closes to keep weather, pests and drafts out when the dryer is off. It restores proper airflow at the outside vent hood. What it does:

• Opens with dryer airflow to allow exhaust to escape and closes when idle to block outside air.
• Helps prevent backdrafts, pests and rain from entering the vent system.
• Can restore normal drying performance when a stuck or broken flap was restricting airflow.
• Commonly replaced when the flap is cracked, warped, jammed or does not seal.

• One vent flapper/exterior exhaust flap.

• Disconnect power to the dryer (and gas supply if applicable) and work from the outside hood when possible.
• Remove the exterior vent hood or access cover to inspect and replace the flap; basic hand tools required.
• Check that the flap moves freely after installation and seats against its seal to prevent air leaks.
• Clean or repair the ductwork to avoid repeat failures.

Upper basket wheel and axle assembly for your dishwasher. Replaces worn, broken, or missing rack rollers that cause difficulty sliding the upper rack.

If rinse aid leaks from your dishwasher dispenser, this cap seals the reservoir to prevent leaks and ensure proper dispensing during wash cycles.

Replacement finger indexer for dishwasher dishrack. Installs on the left side to guide and separate dishes. Replace if cracked, broken, or missing.

Structural bracket that secures and supports the dishwasher wheel assembly. Replace if cracked, broken, or damaged to restore proper rack stability.

Replace your dishwasher's upper spray arm water conduit. This component directs water to the upper spray arm. Order a new conduit if yours is cracked or broken.

Water conduit tube that routes water to the dishwasher's upper spray arm assembly. Replace if cracked, split, or leaking to restore proper flow.

Replacement vent duct for your dishwasher. This connecting duct channels air during the drying cycle. Order a new one if yours is cracked or damaged.

Black plastic insert that covers the door latch mechanism on your dishwasher. Replace when cracked, broken, or missing to restore a clean, finished look.

Fix a dishwasher door that won't stay closed or latch properly with this door latch assembly. Common solution for doors that pop open during cycles.

Replaces a cracked or broken lower manifold support in your dishwasher. This structural component secures the spray arm assembly in place.

Replacement mounting screw for dishwashers. Secures internal components and panels. Order a new screw if yours is stripped, missing, or damaged.

Fix a dishwasher that won't start or has unresponsive buttons with this control board. Common solution when start button fails or cycles won't begin.

Dishwasher won't power on or cycles won't start? This control board manages cycle selection and timing. Intermediate repair, 30-45 minutes typical.