General Electric Dishwasher Parts

Seals the tub light housing to block moisture and debris, preventing leaks and premature bulb failure. Replace if cracked or missing. Verify fit.

Black edge guard trim for dishwasher door or panel. Replaces cracked, broken, or missing trim pieces to restore a finished appearance.

Replace your dishwasher vent gasket to prevent moisture leaks and maintain proper drying. Essential when you notice water escaping or poor drying performance. Verify fit with your model number.

Replacement pushbutton for dishwasher control panel. Installs on the front console to operate cycle selections. Order if your button is cracked or missing.

Replace your dishwasher's door latch handle knob if it's cracked, broken, or missing. This control knob secures the door latch mechanism for proper closure.

Insulating switch cover for dishwashers. Protects electrical switch components from moisture and heat. Replace if cracked, broken, or missing.

This is a small flapper valve located in the dishwasher vent assembly that opens to release steam and hot air during the drying cycle. It closes during wash cycles to prevent water from escaping. Replace this flapper if dishes are not drying properly, if you notice steam leaking during the wash cycle, or if the flapper is warped, cracked, or stuck.

Dishwasher dishrack finger indexer snaps onto the rack to help guide and position dishes during the wash cycle. Replace if broken, cracked, or missing.

This vent flapper is the exterior exhaust flap that opens to let dryer air and lint exit and closes to keep weather, pests and drafts out when the dryer is off. It restores proper airflow at the outside vent hood. What it does:

• Opens with dryer airflow to allow exhaust to escape and closes when idle to block outside air.
• Helps prevent backdrafts, pests and rain from entering the vent system.
• Can restore normal drying performance when a stuck or broken flap was restricting airflow.
• Commonly replaced when the flap is cracked, warped, jammed or does not seal.

• One vent flapper/exterior exhaust flap.

• Disconnect power to the dryer (and gas supply if applicable) and work from the outside hood when possible.
• Remove the exterior vent hood or access cover to inspect and replace the flap; basic hand tools required.
• Check that the flap moves freely after installation and seats against its seal to prevent air leaks.
• Clean or repair the ductwork to avoid repeat failures.

Upper basket wheel and axle assembly for your dishwasher. Replaces worn, broken, or missing rack rollers that cause difficulty sliding the upper rack.

If rinse aid leaks from your dishwasher dispenser, this cap seals the reservoir to prevent leaks and ensure proper dispensing during wash cycles.

Replacement finger indexer for dishwasher dishrack. Installs on the left side to guide and separate dishes. Replace if cracked, broken, or missing.

Structural bracket that secures and supports the dishwasher wheel assembly. Replace if cracked, broken, or damaged to restore proper rack stability.

Replace your dishwasher's upper spray arm water conduit. This component directs water to the upper spray arm. Order a new conduit if yours is cracked or broken.

Water conduit tube that routes water to the dishwasher's upper spray arm assembly. Replace if cracked, split, or leaking to restore proper flow.

Replacement vent duct for your dishwasher. This connecting duct channels air during the drying cycle. Order a new one if yours is cracked or damaged.