General Electric Microwave Guard, Shield, Barrier Parts

This out case (U-bending) is a replacement outer case component used to protect and route a U-bend tube assembly in select appliances. It restores proper routing and protects tubing from pinch or abrasion. What it does:

• Holds and guides a U-bend tube section to maintain correct routing and spacing
• Protects tubing from contact, abrasion, and accidental kinks
• Helps maintain stable refrigerant/water/line placement that can prevent leaks or flow restriction
• Matches the original mounting points for a direct replacement

• One out case (U-bending) as shown

• Inspect surrounding tubing and seals for damage while replacing this part
• Use basic hand tools; avoid over-tightening fasteners that could deform tubing
• Disconnect power (and water or refrigerant service per OEM guidance) before servicing

This outer case is the appliance's external cabinet panel that protects internal components and restores the unit's appearance. It provides a finished exterior and helps keep parts secure and covered. What it does:

• Replaces a cracked, dented or damaged outer cabinet to restore appearance and protection
• Shields internal components from dust, spills and accidental contact
• Provides mounting and alignment for outer trim and controls
• Helps maintain proper airflow paths and component clearance

• One outer case

• Disconnect power before beginning any repair
• Removal/installation typically requires removing fasteners and carefully lifting the cabinet to avoid damaging trim or wiring
• Keep sharp edges and corners in mind; wear gloves to protect your hands
• If the part secures wiring or panels, verify all connections and fasteners are reinstalled for safe operation