General Electric Range Control Board

Control knob not responding or inaccurate? This encoder assembly converts knob rotations into signals for your range control board, restoring precise input.

Oven display blank or unresponsive? This electronic control board manages bake/broil cycles, temperature settings, and the control panel interface.

If your oven won't heat, displays errors, or buttons don't respond, this electronic control board manages heating cycles and user interface functions.

Fixes ovens that shut off after preheating, won't heat, or have unresponsive buttons. This control board manages bake/broil cycles and display functions.

Oven won't reach temperature or displays error codes? This electronic control board manages oven timing, temperature control, and self-clean functions.

This relay board assembly controls and routes power to key appliance components, restoring reliable switching for motors, compressors, or heating elements. Replacing a failed relay board can resolve intermittent operation and restore normal function. What it does:

• Switches power to major loads so motors, compressors, or heaters run when commanded
• Replaces worn or failed relays that cause intermittent starts or clicking noises
• Helps stop erratic operation or loss of function in affected circuits
• Prevents overloads from passing through a damaged relay assembly (when replaced)

• One relay board assembly

• Disconnect power to the appliance before starting any repair to avoid shock or damage
• Handle the board carefully; avoid touching contacts and use ESD precautions if available
• Verify connector orientation and seat all wiring harnesses fully during reassembly

Range not heating or igniting? This control relay board routes power to igniters and burners. Fixes intermittent operation and failed starts on gas ranges.

The Encoder Assembly is an OEM part for GE gas ranges. It digitally converts analog knob movements into signals to control the gas valve, igniter, and temperature settings. 

Causes of a bad encoder assembly include degradation of internal sensors and switches over time, loose wiring connections, or impacts that cause misalignment.

Symptoms of a bad encoder assembly are:

• Delays or errors when trying to light burners
• Inaccurate flame height and temperature level responses 
• Knobs feel sticky, sluggish or jump between settings
• Error codes indicating control module communication issues

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore gas range models.

Fix burners that won't ignite or turn off when your gas range control knobs aren't responding. This reed switch board detects knob positions.

This display board controls the time and temperature readout on the front of the range, typically using a VFD (vacuum fluorescent display) screen. It communicates with the main control board to show oven temperature, cook time, and clock functions. Replace this board if the display is dim, flickering, showing incorrect readings, or completely blank while the range otherwise powers on.

If your gas range display is blank, oven won't heat, or temperature climbs uncontrollably, the control board likely failed. Moderately easy DIY repair.

If your range clock is flickering or oven buttons won't respond, the control board likely failed. Moderately difficult repair requires removing the control panel.

If your oven won't shut off, buttons aren't responding, or temperature won't adjust, the control board may have failed. Takes about 20 minutes to replace.

Self-clean cycle won't start or complete? This timer assembly controls oven cleaning cycles and basic timing functions on electric ranges.

Gas burners won't light? This ignition generator board sends spark signals to igniters for reliable burner lighting. Intermediate difficulty repair.

Fix a range clock that won't display time or control oven functions with this timer control board. Complex repair—professional installation recommended.