General Electric Range / Cooktop / Oven Oven Control Or Thermostat

This oven thermostat regulates cavity temperature to the set point on your range. Replacing a worn thermostat restores accurate heating and proper cycling, helping resolve undercooked or overbaked results, long preheat times, and temperature drift.

• Senses oven temperature via a capillary bulb and opens/closes internal contacts to maintain the selected setting
• Fixes ovens not reaching set temperature or running too hot/too cold
• Addresses ovens that won't cycle off or heat continuously
• Helps improve erratic temperature swings, inconsistent baking results, and extended preheats

• Disconnect power and allow the appliance to cool completely; turn off gas supply if applicable
• Note the exact routing of the sensing bulb/capillary; do not kink or sharply bend it, and reinstall bulb clips in the original location
• Transfer mounting hardware and the control knob as needed; align the shaft to match the original orientation
• After installation, verify operation with an oven thermometer; for gas models, leak-check any disturbed connections with an approved solution

This oven temperature control thermostat regulates heat by cycling the elements to maintain your set temperature. Replacing a worn thermostat helps restore accurate baking and consistent, reliable oven performance.

• Senses oven temperature and opens/closes contacts to hold the selected setting
• Can resolve inconsistent baking results, extended preheat, or erratic cycling
• In some failures, the oven may not heat at all

• Disconnect power at the breaker and allow the appliance to cool before service
• Access the control area; move wires to the new thermostat one at a time to match positions
• Route and secure the sensing probe/tube along the original path and retainers; avoid kinks or sharp bends
• After installation, verify temperature with an oven thermometer and calibrate per service instructions if needed

This thermostat door lock assembly secures the temperature control area and helps ensure consistent thermostat operation. It replaces a worn or broken door lock to restore proper door closure and temperature performance. What it does

• Secures the thermostat/temperature control compartment door to help maintain consistent internal temperatures.
• Replaces damaged or broken lock components that prevent the door from latching properly.
• Helps stop drafts and reduce temperature fluctuation caused by a loose or non-latching control door.
• Common symptom: door won't stay closed or the thermostat cover won't latch.

• One thermostat door lock assembly.

• Disconnect power to the appliance before attempting any repair to avoid shock or injury.
• Handle plastic components carefully to avoid breakage; use appropriate hand tools.
• If mounting hardware or trim is damaged, replace those parts as well.