General Electric Range Endcap Parts

This right-side end support secures and centers the appliance's rotating assembly so the motor and blower run smoothly. It restores proper alignment and reduces rubbing or wobble that can cause noise or airflow issues. What it does:

• Holds the motor shaft or fan spindle in place to maintain correct rotation alignment
• Keeps the blower/fan wheel properly seated to prevent contact with housing
• Helps reduce vibration and audible noise from a loose or worn support
• Supports reliable airflow by preserving correct component spacing

• One right-side end support

• Disconnect power before starting any repair
• Access may require removing panels or components; keep fasteners organized
• Inspect mating surfaces and brush away debris before installing to ensure a secure fit

This end support is a small mounting bracket that secures the freezer/refrigerator end panel and helps keep the cabinet aligned for smooth door operation and proper seal. It replaces a worn or broken support to restore stability and reduce rattling. What it does:

• Supports and anchors the end panel at the left-front corner of the cabinet
• Maintains correct panel alignment to help doors and seals close properly
• Reduces vibration, shifting, or rattling caused by a damaged or missing support
• Fits into mating slots/tabs on the cabinet frame as the OEM bracket does

• One end support (left-front)

• Basic hand tools required; remove power to appliance before service
• Handle parts carefully to avoid scratching painted surfaces
• Inspect adjacent clips, screws and panels and replace any damaged fasteners

This end support holds the dryer drum in place and provides a stable mounting point for the drum shaft, helping the drum spin smoothly. Replaces a worn or broken support to reduce noise and drum wobble. What it does:

• Supports the drum shaft at the rear of the dryer for proper alignment
• Helps maintain smooth drum rotation and belt tracking
• Can reduce scraping, grinding or thumping noises caused by a damaged support
• Prevents excessive drum movement that can wear belts or other components

• Disconnect power to the appliance before beginning any repair
• Remove the dryer front or rear access panels to access the drum and support
• Note the support orientation and any mounting clips or screws; reinstall in the same position
• Inspect the drum shaft, glides and belt for wear while replacing the support

Replace your range's cracked or missing endcap with this structural trim piece. Installs at the end of the control panel or cooktop edge for a finished look.

Right end support cap for gas ranges. Secures and covers the side panel edge. Replace if cracked, broken, or missing to restore a finished appearance.

End support cap for gas ranges. Installs on the side panel to provide structural support and a finished appearance. Replace if cracked or missing.

Replacement right-side end support bracket that secures and aligns the range door assembly. Replace when cracked, broken, or worn to restore proper fit.