General Electric Wall Oven Bumper, Bushing, Grommet Parts

This is a flat metal washer used to secure fasteners and maintain proper spacing on the appliance. It provides a simple, durable spacer that helps keep components aligned and fasteners snug for reliable performance. What it does:

• Acts as a spacer to maintain correct clearance between parts
• Distributes load from a fastener to prevent pull-through or damage
• Helps keep bolts and screws from loosening under vibration
• Can reduce noise or vibration caused by loose or misaligned components

• Disconnect power (and water if applicable) before beginning any repair.
• Use the correct fastener and orientation for reassembly; replace any damaged hardware.
• Tighten fasteners snugly but avoid over-torquing;
• If the appliance shows continued vibration, noise, or instability after replacing the washer, further inspection of mounting hardware and suspension components is recommended.

This push-type plastic rivet is a small fastening clip that secures trim, panels and lightweight components on appliances. It replaces worn or broken rivets to restore a snug fit and reduce rattles or loose trim. What it does:

• Secures interior or exterior trim, panels and access covers
• Holds wiring harnesses or insulation in place where a low-profile fastener is required
• Replaces missing or damaged rivets that cause loose panels or vibration noise
• Simple push-in design creates a firm hold without screws or adhesives

• Disconnect power to the appliance before working on panels or wiring
• Push the rivet stem into the hole until it snaps; remove by prying out the center pin or using pliers
• Use the same style and size rivet as the original to ensure proper fit and retention
• Protect surrounding surfaces from tools and work deliberately to avoid damage

A small plastic spacer that fits behind a refrigerator or freezer door handle to keep the handle properly spaced and aligned. Restores flush fit and reduces rubbing or binding so the handle operates smoothly. What it does:

• Positions the door handle at the correct distance from the door surface for proper alignment.
• Prevents the handle from rubbing against the door or trim, reducing wear and noise.
• Helps maintain secure attachment and consistent handle operation.
• Common symptom: handle sits unevenly, rubs, or feels loose at the mounting point.

• Remove the door handle per the appliance manufacturer's instructions before replacing the spacer.
• Align spacer behind the handle, then reinstall mounting hardware; do not overtighten screws.
• Use basic hand tools; wear gloves to protect your hands and the door finish.

This flexible rubber grommet cushions and protects wiring and components where they pass through panels or openings. It helps prevent chafing, reduces vibration contact, and keeps wiring routed cleanly for reliable appliance operation. What it does:

• Cushions wiring or hoses at panel and chassis openings to prevent abrasion
• Minimizes vibration transfer and rattling where parts pass through openings
• Helps seal small gaps against dust and moisture intrusion in local areas
• Keeps wiring and harnesses routed and centered through openings

• Disconnect power to the appliance before starting any work
• Remove the trim or panel necessary to access the grommet opening; use proper tools to avoid damage
• Inspect surrounding wiring and replace any damaged insulation before reinstalling the grommet
• Press the grommet into the panel opening so it seats fully; use a small amount of appliance-safe lubricant if needed