General Electric Washer Dryer Combo Screws, Nuts, Washers

This SCR 8-18 AB 1/2 is a replacement silicon controlled rectifier that restores proper power control to the appliance's control circuitry, helping the unit switch and regulate current reliably. What it does:

• Controls current flow in the appliance's power/control circuit for timed or regulated output
• Replaces a failed or intermittent SCR to stop erratic cycling, no-power, or control malfunctions
• Commonly used where electronic switching or phase control is required
• Helps restore stable operation when heating or motor circuits fail to receive proper control signals

• One SCR 8-18 AB 1/2 replacement component

• Disconnect power to the appliance before inspecting or replacing electrical components
• Observe ESD precautions and handle the SCR by its body; avoid touching leads
• Verify wiring and mounting orientation match the original part before final assembly

Secures the washer agitator to the drive shaft. Replace if lost, stripped, or rusted to eliminate wobble and restore proper agitation during wash cycles.

12-pack of inlet hose washers for washers and washer dryer combos. Replace cracked, worn, or missing washers to prevent leaks at water connections.

Secures the drive pulley to the motor shaft in your washer. Replace if worn, loose, or missing to prevent pulley wobble and maintain proper belt alignment.

Mounting screw for dryer cabinet and panel assembly. Replaces lost, stripped, or damaged screws during repairs or part installations. 10-16B x 1.375".

Stainless steel mounting screw for washers and washer dryer combos. Replaces damaged, stripped, or missing screws that secure components during operation.

Mounting screw for washer dryer combo units. Secures internal components and panels. Replace if stripped, missing, or damaged during repairs.

Secures the washer lid hinge to the cabinet for proper alignment. Replace if screw is stripped, missing, or broken to restore smooth lid operation.

This is a 10-14 x 1.00 screw used to secure appliance panels and components. It provides a proper fit for threaded openings and restores fastener integrity after repairs. What it does

• Fastens panels, brackets and trim to the appliance frame

Hex washer head screw for washer dryer combo units. Secures internal components and panels. Replace if missing, stripped, or damaged during repairs.

Replacement mounting screw for dryer assemblies. Secures internal panels, brackets, and components. Needed when screws are stripped, missing, or damaged.