Gibson Parts

Ordered parts from appliance part pros Read more

Ordered new parts Read more

I unplugged the stove ,cut the 50 amp cord off from the terminal block as it was burned took out the terminal block as it to was all melted .installed the new terminal block with a new stove cord back in business Read more

Bought name brand parts to match the stove brand. The fit was perfect and have never had an order arrive the next day from ordering it. Read more

• Not drying dishes properly

Turned off power to dishwasher. Removed front bottom cover of dishwasher and removed the wires going to each end of the heating element. unscrewed the two nuts holding the faulty heating element in place. Then removed bottmo dish rack and spinning washer arm from inside the dishwasher. Removed old heating element and replaced with new one. Installed in reverse order (tightened two nuts, connected wires, etc.). Turned power on as last step and was off and running...or should I say washing. Read more

Ordered new parts Read more

Ordered the part, it arrived the next day! Read more

No problem, 1 min to fix Read more

The clips on the rear side of the drawer box were broken. Easy to locate the part on the website. Part in hand in two days and installed in about five minutes. Needed to remove the drawer and use a 1/4" driver, remove the broken slide and install the new one. Read more

Replace the sprayer in the middle of the dishwasher, the problem was the grommet on the back of it but it's not available individually. Read more

Ordered the part, received it in a couple of days and whammo, everything is fine. So easy. Read more

I ordered the ones I needed & got them very fast. ;o) Read more

• Timer will not advance

Just pulled off old knob and pushed on new one. Read more

Ordered the replacement parts and had them the next day! Very nice. Read more

• No hot or cold water
• Will not stop filling with water
• Will not fill with water
• Leaking

This is my third repair of this type. The first was a stand-alone washer and was very easy, because there was a plate on which the inlet valve assembly was mounted, and it was easily removed. This repair was on a Frigidaire stacked washer/dryer (laundry center). Stacked washer/dryers are typically purchased to save space and are often tucked into a closet. Be sure you can pull it out to access both front and rear. Remove drain hose from drain, detach water hoses, electricity and dryer vent... Read more

Gasket and liner arrived as planned. Clips were a day later. Used "hog ring" pliers to remove the clips, worked great. Pre-punched holes in the gasket did not match the original but the plastic liner did. Used an ice pick to punch the gasket and inserted the clips. This is a chest freezer, so install the hinge side first. Read more