Kenmore / Sears Dryer Clip Or Clamp

Secures wiring harness to prevent chafing and maintain safe wire routing in washers, dryers, and laundry appliances. Replace if loose or broken. Check your model for compatibility.

Secures dryer drum components and prevents rattling. Replace if broken or missing to restore quiet operation. Verify fit with your model number.

Ground strap assembly connects drum shaft to dryer frame for electrical safety. Replace if damaged, corroded, or causing startup squealing noise.

Secures the blower housing in your dryer. Replace if broken, loose, or causing rattling noises during operation. Verify fit with your model number.

Replacement clip that secures trim, panels, or small components to restore proper fit and reduce rattling and vibration. Install when a worn or missing clip leaves trim or panels loose or causes intermittent noise. What it does:

• Holds trim, panels or small assemblies in place to prevent movement
• Stops rattling and vibration caused by loose parts
• Replaces broken or missing clips that allow gaps or misalignment
• Small, snap-in retainer shaped to match original attachment point

• Always disconnect power before servicing the appliance
• Access the clip location by removing the adjacent panel or trim per the OEM diagram
• Clip typically snaps into place; use needle-nose pliers or a flat screwdriver to remove the old clip if needed

Secures internal panels, trim, and wiring to prevent rattles and loose connections. Replace when worn or broken to restore proper fit and quiet operation.

A small OEM-style retention clip used to secure interior panels or trim so those parts stay aligned and rattle-free. Replaces a worn or missing clip to restore a snug, stable fit and cleaner appliance operation. What it does

• Secures panels, trim pieces or other plastic components in place
• Prevents loose panels from vibrating or rattling during operation
• Helps maintain proper alignment of fitted parts for a flush appearance
• Commonly replaced when panels are loose, cracked mounting tabs fail, or clips break during service

• One retention clip

• Disconnect power to the appliance before starting any repair
• Remove surrounding panels carefully to access the clip mounting location
• Clip is small and may require a pry tool or needle-nose pliers to install or remove
• Retain any broken clip pieces and replace with the supplied clip; before reassembling