Kenmore / Sears Dryer Heating Element

This replacement heating element restores proper water temperature and drying performance in your dishwasher. It helps dissolve detergent, sanitize, and dry dishes at the end of the cycle for consistent, reliable cleaning results.

• Heats wash water and boosts final rinse temperature to aid drying
• Common failure symptoms: dishes not drying, detergent not fully dissolving, cycles running long, or lukewarm water
• Helps resolve poor cleaning and milky/white residue linked to low water temperature

• Disconnect power at the breaker and shut off water supply before servicing
• Access from underneath; remove toe panel/kick plate as needed and note wiring/terminal orientation
• Inspect and reuse existing seals/hardware if applicable; check for leaks after reassembly
• After install, run a test cycle to ensure proper heating and drying

Dryer not heating or taking too long to dry? This dual heating element restores proper temperature and drying performance. Moderate DIY repair.

Dryer not heating or taking too long to dry? This heating element generates heat to dry clothes. DIY repair typically takes 30-60 minutes with basic tools.

Dryer won't heat or takes too long to dry? This heating element generates the heat needed to dry laundry. Easy DIY fix restores consistent drying temps.

Dryer stopped heating or takes hours to dry? This heating element restores proper heat output. Typical repair takes about an hour with basic tools.

Dryer not heating or taking too long to dry? This heating element generates the hot air needed to dry clothes efficiently. Moderate DIY repair.

This bake heating element replaces the oven's primary heating element to restore consistent bake performance and even oven temperatures. Designed to heat quickly and quietly for reliable cooking results. What it does:

• Heats the oven cavity for baking and general cooking cycles
• Replaces a cracked, visibly burned, or non-heating element
• Helps restore oven temperature recovery and cooking consistency
• Stops symptoms like no heat, weak heat, or uneven browning

• Disconnect power at the breaker before servicing the oven
• Remove the oven racks and access the element from inside the oven
• Secure mounting screws and electrical connectors firmly; avoid overtightening