Kenmore Elite Cap Or Cover

Note: Does not include moisture sensor bars. For the moisture sensor bars, order 2 of part# 6500EL3001A.

The Guide Cover is an OEM part for LG dryers. The part allows dust and debris to exit the dryer drum while preventing small clothing items from slipping through.

Causes of a bad Guide Cover can include accumulation of lint and debris that can restrict airflow, physical damage from handling or excessive use, and general wear that can compromise the fit and effectiveness of the cover.

Symptoms of a bad Guide Cover include:

• Increased drying times due to poor airflow.
• Unusual noises from lint hitting the fan or other components.
• Overheating of the dryer.
• Visible damage or misalignment of the cover that affects performance.

This OEM LG part is also compatible with Sears/Kenmore.

The Lint Filter Duct Cover is an OEM part for LG dryers. It is designed to fit over the lint filter and duct area, ensuring that lint is properly trapped and does not escape into the dryer’s internal components. This cover helps maintain efficient airflow and prevents potential lint buildup, which can be a fire hazard. This part measures approximately 11-1/2 inches by 1-1/4 inches.

You should replace the lint filter duct cover if it becomes damaged or cracked, or if it fails to stay securely in place. Common causes of a bad lint filter duct cover include regular wear and tear, accidental damage during cleaning or maintenance, or exposure to high heat that can warp the plastic.

Symptoms of a bad lint filter duct cover include:

• Lint escaping into the dryer drum
• The cover not fitting securely over the lint filter
• Increased drying times due to reduced airflow
• Visible cracks or damage to the cover

This OEM LG part is also compatible with Sears/Kenmore models.

This is the small trim cap that snaps over the end of a refrigerator door handle. It finishes the handle, covers the mounting hardware, and helps keep the handle secure and looking clean.

• Covers exposed door-handle screws and mounting points
• Restores a finished appearance if the original cap is missing or damaged
• May help reduce handle looseness if the old cap no longer held properly
• Common symptoms: missing end cover, visible handle screws, loose or rattling handle

• Unplug the appliance before starting and open the door for access
• Remove the old cap by gently prying at the seam; avoid scratching the door finish
• Align the new cap with the handle end and press until it snaps fully into place
• If required, tighten handle mounting screws before installing the cap

This snap-in hole plug button covers unused panel openings to restore a finished look and help keep out dust and moisture. A simple cosmetic trim piece that snaps into place and blends with the control panel. What it does:

• Covers exposed holes in control panels and consoles to improve appearance
• Helps block dust, lint and small debris from entering appliance openings
• Prevents accidental contact with internal components through unused holes
• Useful when replacing damaged buttons or finishing a repair

• One snap-in hole plug button

• Disconnect power to the appliance before working on the control panel
• Press the plug into the hole until it snaps flush; use a flat tool gently if needed
• Inspect fit and panel edge for damage; replace if cracked or loose to ensure a secure fit
• If panel removal is required, follow manufacturer instructions to avoid breaking clips