Kenmore / Sears Ice Door Or Ice Chute

Covers the ice chute in your refrigerator's dispenser. Replace if the door is cracked, broken, missing clips, or won't stay closed properly.

The refrigerator ice maker hole plug is a rubber or plastic cap that seals the pre-drilled opening in the refrigerator cabinet wall that is used for ice maker water line connections. It keeps cold air from escaping through the unused hole in refrigerators that do not have an ice maker installed. Replace or install this plug if cold air is leaking through an open hole in the back wall of the refrigerator, causing temperature fluctuations or frost buildup.

Refrigerator ice chute door assembly mounts in the freezer door to direct ice cubes into your glass. Replace if cracked, broken, or missing.

This is a water supply line that connects to the refrigerator's dispenser system, routing water from the internal plumbing to the dispensing mechanism. It ensures a steady flow of water for the water dispenser and may also support ice maker function. Replace this line if you notice leaking behind or under the dispenser area, reduced water flow, or water dripping from the dispenser chute.

Directs cold air from the freezer to the ice maker assembly. Replace if the duct is cracked, broken, or blocking proper airflow to your ice maker.

Ice chute seal cover for refrigerator ice compartments. Replaces cracked, broken, or missing covers that fail to seal properly around the ice dispenser door.

Replaces broken or cracked ice chute door cover on refrigerator dispensers. Includes spring mechanism. Installs on front dispenser panel.

Ice maker not working or frosting over? This protective cover shields the control module from debris and moisture. Easy 30-minute DIY installation.

Ice door funnel for side-by-side refrigerators. Guides ice from dispenser to door opening. Replace if cracked, broken, or tabs damaged.

This is the front cover door for the ice storage bin inside the freezer compartment. It attaches to the ice container and keeps ice contained while allowing easy access for dispensing. Replace this door if it is cracked, warped, or no longer stays closed, which can cause ice to melt or spill out of the bin.

Directs water into the ice maker fill cup. Replace this funnel if cracked, broken, or missing to ensure proper water flow and prevent spills during ice production.

Directs water and ice from your refrigerator dispenser into cups. Replace if cracked, broken, or missing to prevent spills and restore proper flow.

This funnel assembly directs detergent and rinse water from the dispenser into the dishwasher tub, helping consistent dispensing and preventing spills. Replace a cracked, clogged, or damaged funnel to restore proper detergent flow. What it does

• Channels detergent/rinse solution from the dispenser to the wash tub for normal cleaning cycles.
• Prevents leaks and spills that can occur from a broken or distorted funnel.
• Helps avoid uneven or missed dispensing that can lead to poor wash performance.
• Fits into the dispenser housing and works with the dispenser release mechanism.

• One funnel assembly.

• Disconnect power to the appliance before inspecting or servicing the dispenser.
• Remove the inner door panel or dispenser cover as needed to access the funnel; keep track of fasteners.
• Inspect and replace any worn seals or clips when installing the new funnel.

Ice chute funnel directs ice from dispenser to glass. Replace if cracked, broken, or missing to prevent ice spillage and ensure proper delivery.

This is a protective cover that fits over the ice maker compartment inside the refrigerator or freezer section. It shields the ice maker mechanism and helps maintain proper temperature around the ice-making components. Replace this cover if it is cracked, warped, or missing, which can allow warm air into the ice maker area and reduce ice production.

This funnel assembly guides ice from the dispenser mechanism down through the chute and out of the refrigerator door. It ensures ice is directed properly into your glass without scattering or jamming. Replace this part if ice frequently misses the glass, gets stuck in the chute, or the funnel is cracked or broken.