Kenmore / Sears Refrigerator Support Parts

Support frame for refrigerators. Mounts internally to provide structural support. Replace if cracked, broken, or damaged to restore proper alignment.

This is a metal mounting rail used to secure the compressor unit to the base of the refrigerator. It provides stable support and helps reduce vibration during compressor operation. Replace this rail if it is bent, cracked, or corroded, or if you notice excessive vibration or unusual noise coming from the bottom of the refrigerator.

Support plate for freezer interior mounting. Replaces cracked, broken, or missing support plates that compromise shelf or component stability.

Mounting plate that secures the valve switch inside your freezer. Replace if the original plate is cracked, broken, or missing to properly support components.

This is a protective case assembly that houses the printed circuit board (PCB) for the refrigerator's ice dispenser or display panel. It encloses and shields the electronic control board from moisture and physical damage. Replace this assembly if the housing is cracked, melted, or damaged, or if you need to access or replace the control board inside.

Replacement mounting plate for refrigerators. Provides a stable surface to secure components. Needed when original plate is cracked, broken, or missing.

Support plate for refrigerators. Mounts inside cabinet to secure components. Replace if cracked, bent, or missing to restore proper structural support.

Left-hand support gusset plate for top-mount refrigerators. Replaces cracked, broken, or missing structural brackets that secure internal components.

This left-side tapping plate/gusset is a metal mounting bracket that reinforces appliance panels and hinge areas, restoring secure attachment and alignment for doors or panels. It helps reduce wobble and maintains proper fit where the original bracket is damaged or worn. What it does:

• Reinforces and secures hinge or panel attachment points to restore alignment
• Provides a threaded or tapped surface for fasteners where sheet metal cannot accept screws
• Stops movement or sagging that can cause gaps, noise, or poor door sealing
• Helps prevent further damage to the cabinet or door mounting area

• Always disconnect power (and water, if applicable) before beginning repairs
• Inspect mounting holes and surrounding metal; remove any damaged fasteners or debris before installing
• Use the correct replacement screws and hand-tighten, then torque to manufacturer specs if available; do not over-tighten
• If the cabinet or hinge area is severely corroded or stripped, additional repair or reinforcement may be required

Lower hinge tapping plate for refrigerators. Secures the bottom door hinge to the cabinet frame. Replace if cracked, stripped, or damaged.