Kenmore / Sears Wall Oven Parts

I tried swapping the cables around by putting the cables from the burners that would light onto the ones that didn't light. When I did that the problem would move. So this is how i determined that the issue was with this module and not the burners or cables. Once this new module arrived it was simple to disconnect the old one and put the cables back on the new one. I tested it (holding by breath!) and then all of the burners started. HOORAY! Read more

Replaced spark module - oven was less than two years old. Like a lot of new gas ovens, turning on any one burner to 'lite' sends sparks to all 5 top burners. The difficulty was getting to the spark module, as some generic videos show access to it from the upper panel on the back of the oven, but it wasn't there. Had to take off the entire top burner panel of the oven to get to the module, and then it was simple to replace the module by transferring the wires to the new one. I did see on... Read more

Replaced spark module and all electrodes/igniters. Read more

• Won't start

Replaced module: Although the new module was slightly different due to a third or ground terminal that was not on the original I managed to figured out that I did not need to worry about the ground since the existing wiring had already allowed for the connection. Easy repair. I ordered the part one day and it was delivered the next and that was using the least expensive delivery service. You guys are great Read more

Watched repair video's to learn where parts were located. Put replacement in and it worked great! Read more

Replaced the ignitor module ( a plug in direct replacement) a monkey could have performed this repair Read more

Replace spark module. Read more

I first called an appliance service co. and they came the next day. They discovered it was the spark module but they did not have one in stock. They would call, when it was in, for a return visit. After a few days of waiting and lighting the burners by hand, I looked in the internet and found the AppliancePartsPros.com, and typed in my problem. They told me what I needed to do to fix it. I watched the video on replacing the part, and then ordered the part. It was here the next day. I took the... Read more

Changed the spark module electronic board. I ordered part # AP5999387 (W10860916) Read more

Replaced all gas lines (orifices), electrodes, and the spark module. Now, works like a charm. Not a hard fix at all. First time doing repair, so I took my time. Read more

Replaced the spark module (2 + 0) Now it is working fine. Read more

• Won't start

Tappen Gas Stove circa 1981 (uses Fridgidaire parts). Unplugged stove from 110 wall outlet. Spark control module located on back side of stove about mid-way down on left side under a black cover that juts out. Black cover had 2 phillips head screws...removed the black cover and the spark module was right there...held on by 2 additional phillips screws. Sprark module purchased was identical to old one on the stove. Removed each wire, one at a time from the old spark module (slide off) and placed... Read more

New spark module Read more