Kenmore / Sears Washer Endcap Parts

This trim piece finishes and protects an opening or edge on your appliance's cabinet or console. Replacing a cracked or missing trim restores a clean, factory look and helps nearby components sit and operate as intended. What it does:

• Provides a clean, finished edge and covers sharp cabinet/console edges
• Helps keep adjacent parts aligned and secured around the opening
• Restores appearance when original trim is cracked, warped, discolored, or missing
• Common symptoms: loose or rattling piece, cosmetic damage, snagging edges, or poor fit of nearby parts

• 1 trim piece

• Disconnect power; if applicable, shut off gas or water. Wear cut-resistant gloves.
• Remove the existing trim by releasing clips or removing screws; note orientation and retain hardware.
• Transfer any reusable clips/inserts from the old trim to the new part.
• Align and snap/screw the new trim into place; do not overtighten.

Replacement end cap that restores the appliance's finished edge and helps protect internal components from debris. A simple, low-cost repair to replace cracked, broken, or missing end caps and reduce trim wear. What it does:

• Covers and protects an exposed edge or end of the cabinet/trim.
• Helps prevent snagging, dirt buildup, and contact damage where the cap is missing or cracked.
• Restores the appearance and alignment of surrounding trim pieces.
• Common symptom: visible crack, loose or missing trim, rubbing or catching at the edge.

• Disconnect power and/or water supply to the appliance before beginning work when applicable.
• Inspect the mating surface and remove old adhesive or fasteners before installing the replacement cap.
• Install by aligning the cap and snapping or fastening into place; do not force—use correct fasteners if applicable.
• If surrounding trim is damaged, consider replacing affected pieces to ensure proper fit and finish.

This right-side end cap fits the dryer's drum assembly and restores proper alignment and support for smooth, quiet operation. It replaces a worn or damaged end cap to reduce drum wobble and related noise. What it does:

• Supports and positions the drum at the right end to maintain proper rotation
• Helps prevent rubbing, scraping, or metal-on-metal contact that can cause noise
• Restores secure mounting for associated rollers/bearings at the right side
• Can be replaced when the end cap is cracked, broken, or visibly worn

• One right-side end cap

• Disconnect power to the appliance before beginning any repair
• Access typically requires removing the dryer front panel or bulkhead
• Inspect related rollers, bearings, and mounting hardware; replace any worn parts to prevent repeat failure
• Reassemble panels and verify the drum spins freely and without unusual noise