Kenmore / Sears Washer Panel Parts

This replacement front panel restores the appliance's exterior appearance and protects internal components behind the cabinet face. It provides a clean mounting surface for trim, controls, and the door opening while keeping debris out. What it does:

• Replaces a cracked, dented, or damaged front panel to restore cosmetic appearance
• Protects internal components and control openings from dust and debris
• Provides a stable mounting surface for trim, latches, and door seals
• Helps maintain proper alignment of the door or access area

• Disconnect power (and water, if applicable) before beginning any repair
• Remove trim, bezels, or the door as required to access mounting fasteners
• Handle the panel carefully to avoid bending or scratching during installation
• Use manufacturer-recommended fasteners and verify alignments before tightening

This is the rear panel that covers the back of the washing machine, protecting internal components from dust and debris. It provides structural support and helps enclose the drum, motor, and wiring. Replace this panel if it is dented, rusted, cracked, or missing, which can leave internal parts exposed to damage.

This cabinet top panel replaces the appliance's upper exterior surface to restore a flush fit and finished appearance. It protects internal components and helps maintain proper alignment of the control area and lid/door. What it does:

• Covers and protects the appliance cabinet's upper area from debris, spills, and wear
• Provides a mounting surface and alignment for the control assembly and lid/door
• Stops drafts, reduces rattling, and restores a uniform exterior fit and finish
• Addresses symptoms such as gaps at the top, loose or misaligned control area, or visible surface damage

• Disconnect power (and water supply for washers) before beginning any work.
• Removal/installation may require removing the control console or front/side trim; keep screws and small parts organized.
• Align tabs and screw holes carefully to avoid scratching the finish; hand-start fasteners before tightening.
• Inspect and replace sealing or trim pieces if damaged to ensure a proper fit.