Kitchenaid Dishwasher Parts

Protective housing cap that encases the dishwasher thermostat. Replace if cracked, broken, or missing to properly shield temperature monitoring components.

Captures food particles in your dishwasher's sump area. Replace if clogged, damaged, or dishes aren't cleaning properly. Verify fit with your model number.

Fix weak water circulation and poor cleaning in your dishwasher. This impeller and seal kit restores pump function when dishes aren't getting clean.

This dishwasher rack repair kit contains touch-up paint to restore damaged or chipped dish rack coating. It prevents rust and maintains the protective finish on wire racks. Use it to repair small chips or worn spots that could snag dishes or spread rust.

Shield for dishwashers. Protects internal components from heat and water damage. Replace if cracked, broken, or missing to maintain proper coverage.

Dishwasher door seal creates a watertight barrier to prevent leaks during wash cycles. Replace if cracked, torn, or causing water leakage. Verify fit with your model number before ordering.

Color: Black. For white use W10021870. For stainless W10021850

Mounting bracket for dishwasher installation. Secures unit to cabinet or countertop. Replace if bent, broken, or missing during installation or repair.

Replace your dishwasher's internal wire harness if connectors are melted, wires are brittle, or insulation is damaged from overheating or wear.

Sound dampening insulation pad for dishwashers. Installs on cabinet walls or door to reduce noise. Replace if cracked, torn, or missing.

Replace your dishwasher's touch pad overlay if it's cracked, peeling, or worn. This control panel cover installs over the keypad for a fresh look.

Replace your dishwasher's touch pad overlay if the control panel surface is cracked, peeling, worn, or unresponsive. Restores the appearance of your unit.

This replacement name plate restores the appliance's front identification/trim for a clean, factory appearance and helps keep labels and controls visible. It's a simple cosmetic/replaceable part for worn, cracked, or missing name plates. What it does

• Replaces a faded, cracked or missing name plate to restore original appearance
• Provides the visible label/trim that surrounds or covers controls and branding
• Helps prevent dirt and grime from collecting behind exposed openings
• Restores a finished look after panel or control repairs

• One name plate

• Disconnect power to the appliance before starting any work
• Typically installs with snaps or screws; align carefully and avoid forcing the plastic
• Use appropriate tools for specific steps
• Replace with OEM hardware for correct fit

This is a small flapper or float valve located at the water inlet area of the dishwasher. It helps prevent water from flowing back out of the tub by acting as a one-way check valve. Replace this part if you notice water leaking from the inlet area or if the dishwasher is not filling properly due to water draining back out.

This is a protective shield that mounts over or near the detergent dispenser inside the dishwasher, shielding it from direct heat generated by the heating element during the drying cycle. It prevents heat damage that could cause the dispenser to warp or malfunction. Replace this shield if it is cracked, warped, or missing, which can lead to dispenser door failures or detergent not releasing properly.