Kitchenaid Range Parts

Fix burners stuck on high or with no heat control. This infinite switch restores precise temperature adjustment. DIY-friendly repair in under an hour.

This fixed thermostat switches near 60C to control a heat-managed circuit—often the oven's cooling/blower fan. Replacing a failed unit restores proper fan cycling and helps protect the control area from excessive heat during and after cooking.

• Monitors temperature in the oven cabinet/control area and switches power based on heat level
• Cycles the cooling/blower fan on and off to manage cabinet temperature
• Helps safeguard electronic controls from heat buildup
• Failure may cause symptoms such as a fan that won't run, a fan that runs continuously, or an unusually hot control area

• Disconnect power at the breaker before servicing
• Access the thermostat per your model; it is typically mounted to a plenum or bracket near the oven cavity
• Move wires one at a time and mount the new thermostat flat against the surface for accurate sensing
• Restore power and verify the fan cycles during operation

This factory replacement filter helps protect your appliance by trapping unwanted debris and contaminants so the system can perform as designed. Replace a damaged or clogged filter to restore proper flow and dependable operation. What it does

• Screens particles to protect internal components and maintain airflow or water flow
• Helps sustain performance and reduce wear on the appliance
• Common signs it's time to replace: reduced flow/venting, lingering odors, or visible damage
• Preventive replacement can help maintain efficiency over time

• 1 filter

• Disconnect power to the appliance; shut off water supply if applicable
• Access and remove the old filter, noting orientation and seals
• Install the new filter fully seated; do not overtighten any fasteners or fittings
• Restore power (and water, if used) and check for proper operation and leaks/airflow

Burner won't heat or heats unevenly? This surface heating element restores reliable heat to your electric cooktop. Moderate DIY repair in 30-60 minutes.

Replace your cracked, stripped, or missing electric range control knob. Mounts on the control shaft to restore smooth setting selection and a clean look.

Cast iron burner grate for gas ranges and cooktops. Sits atop burners to support pots and pans. Replace if warped, melted, cracked, or damaged.

Secures range door panels and internal components to the cabinet frame. Replace if bracket is cracked, broken, or bent to restore proper door alignment.

Burner won't heat or heats inconsistently? This surface element restores cooking performance. Simple swap-out repair—unplug old, plug in new.

Fix a dual burner that won't heat or lacks proper temperature control. This infinite switch restores heat regulation for accurate simmer-to-boil cooking.

Fixes igniters that won't stop sparking or burners that won't re-light when flame goes out. Controls ignition system for reliable burner lighting.

Replace a cracked, broken, or missing control knob on your gas range. Installs on the control shaft to restore manual adjustment of burner settings.

Sits atop the burner head to shape flame and shield from spills. Replace if missing, chipped, or warped to restore proper flame pattern and appearance.

Burner won't light or clicks excessively? This spark electrode ignites the gas on your cooktop. Simple repair restores reliable ignition in minutes.

Replace your cracked or broken electric range glass cooktop. This black glass surface installs on top of your range to restore appearance and function.

Replacement burner head for gas cooktops. Distributes gas evenly through flame ports. Replace if damaged, clogged, corroded, or missing to restore burner.

Restores a tight seal between your oven door and cavity to maintain proper temperatures. Replace if you notice heat escaping or uneven cooking. Confirm fit with your model number.