Kitchenaid Refrigerator Parts

Genuine Whirlpool part

Kitchenaid Cam-Door (Door Cam), 1 Count

By: Whirlpool

Part Number: W11778262

This cam-door is the small pivoting cam that helps a washer/dryer or laundry door latch and swing smoothly. Replacing a worn or broken cam restores proper door movement and helps the door close and seal reliably. What it does:

Acts as the pivot/latch cam that guides the appliance door during opening and closing.
Helps the door engage the latch and maintain correct alignment.
Commonly used to stop a door from hanging, binding, or failing to stay closed.
Can reduce door noise or catching caused by a damaged cam.

What's included: Includes: One cam-door. Install notes:

Disconnect power (unplug or switch off breaker) before starting any repair.
Support the door or cabinet panel during removal to prevent dropping or damage.
Remove the door or access panel and replace the cam using basic hand tools; keep track of fasteners.
After reassembly, check door operation and latch engagement before returning the appliance to service.

Do-It-Yourself Stories from Customers like You Door clicking, door not closing easily Mike K. • Broadview Heights , OH • January 27, 2020

Replaced both sets of door cams on my Kenmore Elite Refrigerator. The most important thing to know is that you DO NOT have to remove the doors from the refrigerator to replace BOTH sets of cams. You just have to remove the lower grill which is a snap fit (I also turned off the water and unplugged the unit). My fridge has an ice and water dispenser where the water and electrical lines go through the cams on the left side. Be sure to order the correct parts as the cam holes on the freezer side... Read more

$6.75

Compare At:: $7.50
You Save:: $0.75

IN STOCK

Ships Today Guaranteed

Add to Cart

Genuine Whirlpool part

Kitchenaid Vertical Mullion Assembly (Flipper Rail), 1 Piece

5.0 (1)

By: Whirlpool

Part Number: WP12722815AP

Restore a tight, even seal between your refrigerator's doors. This vertical mullion assembly flips into place to cover the center gap, helping maintain proper temperatures and reduce condensation.

Bridges the gap between doors to create a continuous sealing surface
Helps keep cold air in and warm air out for consistent cooling
Aids proper door alignment and smooth closing
Common symptoms of a failed mullion: broken or wobbly flipper, doors not closing fully or popping open, moisture/icing at the center, warming in the fresh food section

What's included: 1 vertical mullion assembly Install notes:

Disconnect power before servicing and open the doors
With the door open, release the retaining screws or tabs and lift the old mullion off the upper and lower pivots
Position the new assembly on the pivots, secure it, and verify the flipper moves freely and seals evenly against the opposite door
Restore power and recheck door operation and gasket contact along the full height

Do-It-Yourself Stories from Customers like You Rail mullion on refrigerator. Dallas W. • Monticello , FL • February 16, 2022

Replaced part in entirety. Read more

$141.32

Compare At:: $169.58
You Save:: $28.26

IN STOCK

Ships Today Guaranteed

Add to Cart

Genuine Whirlpool part

Kitchenaid Air Diffuser (Refrigerator Damper Assembly)

4.8 (5)

By: Whirlpool

Part Number: WP2209751

The air diffuser is the damper assembly that meters cold air from the freezer into the fresh food compartment. Replacing a sticking or broken diffuser restores proper airflow and helps keep refrigerator temperatures balanced and consistent.

Regulates and directs airflow from the freezer to the refrigerator compartment
Opens and closes to balance temperatures between sections
Helps prevent warm spots or freezing near vents in the fresh food area
Typical symptoms: refrigerator too warm, items freezing near vents, continuous or no airflow through the diffuser, or frost buildup around the diffuser opening

What's included: One air diffuser assembly Install notes:

Disconnect power before servicing
Access from the fresh food section; remove shelves and the diffuser cover/grille to reach the assembly
Transfer any reusable mounting hardware or seals from the original part
Restore power and allow up to 24 hours for temperatures to stabilize; verify airflow through the diffuser

Do-It-Yourself Stories from Customers like You Refrigerator was not cold enough (hovering around 50 degrees) Marc B. • Rogers , AR • January 03, 2017

The air damper was not operating so the cold air from the freezer could not get into the refrigerator. The part from AppliancePartsPros.com did work but not without a slight modification. I read one post related to the same part where the customer thought he received the wrong part because he couldn't get the clips to engage the freezer wall. The response from this site was that he received the correct part but he just had to push really hard. Armed with this knowledge I was prepared to have... Read more

$183.43

Compare At:: $216.45
You Save:: $33.02

IN STOCK

Ships Today Guaranteed

Add to Cart

Genuine Whirlpool part

Kitchenaid Dryer Door Handle

5.0 (8)

By: Whirlpool

Part Number: WP348721

The Dryer Door Handle is an OEM replacement part for Whirlpool dryers. A dryer door handle can deteriorate due to prolonged use, repeated force when opening or closing the door, or accidental impact that causes cracks or breakage. These factors may compromise the handle's structural integrity and make it less reliable.

Color: White

Symptoms of a bad Dryer Door Handle include:

Loose or wobbly handle
Cracks or visible damage to the handle
Difficulty opening or closing the dryer door

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

Do-It-Yourself Stories from Customers like You Plastic door latch frame deteriorated making latch replacement necessary same deterioration problem with door handle Glenn M. • Modesto , CA • August 16, 2016

Door latch was a snap (literally). Package included Instructions and parts for 3 different latch types and an easy identification method for each type. Just identify the correct latch type for your dryer and "Snap" it in to the cutout on the inside of the dryer door . The Door handle requires you unscrew the small sheet metal screws (three on my dryer) on the top edge of the dryer door. This allows you to separate the two dryer door halves (use a small flat blade screw driver to get the two... Read more

$56.38