Maytag Cooktop Switch

After looking at several YouTube videos that were only moderately helpful for my particular model, I disconnected the power at the breaker, disconnected the wires below the cooktop to the junction boxed lifted the whole unit out, including the fan assembly. I flipped it upside down and took off the screws holding the unit to the glass top. Although the new fan switch did not look the same as the original switch, the new switch does fit. The new switch did not come with a hex nut. The old hex... Read more

• Won't start

By replacing the switch, the front right burner correctly turned on the igniter and worked. Repair took about 5 minutes. Very easy to do. Read more

Replaced switch assembly Read more

I looked up the parts on appliancepartspros.com, made the order, and was amazed how fast the parts arrived! I was able to watch their repair video and it showed me how to change it step by step. Read more

Went on line to find the part number. Once I had the number I searched for the part. Found it, had it shipped overnight and installed it with the help of a video from youtube. Read more

I replaced both the element and the switch. It was a relatively easy fix, although I needed a second set of hands to hold the stovetop upright while I did the replacement. The entire job took about 45-60 minutes. Read more

Ordered the part and a few days later it arrived and I turned off the power and took a few screws out and unpluged the old one and pluged in the new .. Works like a charm.. Was very easy to fix.... Read more

Ordered new igniter, a little different from the original but fortunately was able to get it to operate ok with a little bit of modification ?? Read more

Removed rocker switch,made up jumper so the compactor could be used while awaiting replacement switch. The part came 2 days later and was installed in less tha 5 minutes. Unit working like new again. Thanks for the great service!! Read more

Replaced igniter switch harness Read more

Watched appliance parts pros video on YouTube to determine which part to replace. Ordered parts and followed how to video and replaced parts. Read more

Replaced shorted wire and blown switches. Read more

I replaced the whole unit of the switching spark. Read more

• Won't start

I installed two burner ignitions under the knobs then installed a new spark module, which I had to order from a different vendor as this is a 20+ year old Caloric stove. Fortunately this spark module is used in many other appliances. Read more