Maytag Wall Oven Parts

Installed it according to video watched. Read more

Had to drill out the portion of the old foot that was still in the grate. Cleaned out the opening. Popped in the new one and voilà- all fixed. I ordered 8 of the feet as I see this eventually happening to all of them. Read more

Oven part was hard to fix as space was very small, it took longer than even you tube video said it would Read more

Removed side moldings top molding and glass, removed broken handle. Reinstalled new handle, all modings and glass. Read more

The plastic piece on the handle where the screw goes in to hold glass door up had broke. I ordered new handle, the retainer pieces that go over the plastic pieces to lock it all in and screws that were suggested. The screws were the wrong ones. They were way too small. I already had one screw and thankfully only had to buy 1 new one because the screw was $40 and shipping’s $10 for it AND it’s on back order right now. The old retainer ring that goes over plastic piece was a nightmare to remove... Read more

I was able to clean the Oven Temp Sensor with 99% alcohol. Then replaced All switches (after breaker was isolated). Put it all back the way I found it. Turned on breaker. Tested all functions and had no reports of Fan Code re-appearing since. Read more

Watched videos online and with that knowledge it was a very simple process. Read more

Start by removing the frame on the sides and bottom of the door. (Do not unscrew the corner screw holding the side frame and bottom together.) Be careful the glass will fall once the last screw is removed from the bottom so hold tight. Carefully remove glass and set aside. Remove top frame that held the handle. Once all the frame work and outer glass is removed unscrew the bracket that held the door handle from the door. Taking the top frame and bracket insert screw and washer and screw the... Read more

Replaced two switches that controlled two front burners. One controlled three different burner sizes options in one burner. The other was the speed burner, basically three different burner options in one burner. Read more

Ordered new handle from Appliance Parts Pro and replaced with the new handle. Read more

Replaced the latch. Everything works fine now Read more

I first DISCONNECTED POWER FROM THE RANGE using the breaker. I then pulled the range out from the wall to give myself plenty of working room. I lifted the range top up as when you clean under the burners. I then moved the ends of the bottom of the slide rods that lock the range top open back where they came loose from the top of the range. This allows you to fold it higher and have complete access to the top of the range. I then took out all the Phillips head screws that hold down the sheet... Read more

It was relatively easy to replace it. Some suggestions: 1. Make a platform to support the oven when you slide it out of the cabinet. Make the platform sturdy because this thing is heavy. Make the platform the same height as the cabinet so that you can just slide it out and back in without having to lift it. 2. The fan is secured with about 5 sheet metal screws plus there are 3 screws on the top that the fan slides under when you loosen them. However you can't fit a screw driver in the space to... Read more

So I ordered the burner and Ithe switch because I wasn't sure what part was defective. I pulled the oven out and I removed the 6 1/4 inch screws on each side of the glass top as well as the 2 Phillips head screws on the back, removing the 2 1/4 screws on the shield on the back gIves you easier access to them, then lifted the glass top up on the front to access the switch and burners. Make sure you turn the power off before beginning this process. When lifted up the wires connected to the... Read more

I watched the AppliancePartsPros video on youtube and ordered the glass. It arrived in two days and took 20 minutes to install. Read more