Microwave Door

A complete stainless steel refrigerator door assembly that replaces a damaged or dented door to restore proper closing and appliance appearance. Installs in place of the original door to help maintain internal temperature and reduce air loss. What it does:

• Replaces a damaged, bent or dented exterior door to restore appearance and function
• Helps re-establish proper sealing and insulation to reduce cold air loss and frosting
• Restores correct door alignment and latching for reliable closing
• Prevents drafts and temperature fluctuations that can affect food preservation

• Disconnect power to the appliance and remove contents from the door before starting.
• Installation may require removing hinge hardware; have basic hand tools available and retain all fasteners.
• Two people are recommended to handle and align the door safely during installation.
• Verify hinges and gaskets are aligned and undamaged; adjust per the appliance manufacturer's instructions and test door closing after installation.

This is a replacement microwave oven door assembly that restores a secure, heat-shielding closure and proper door latching for safe cooking. It replaces a damaged, bent, or non-sealing door to help the oven operate normally. What it does:

• Replaces a broken, cracked, or warped microwave door to restore the oven's sealing surface and appearance
• Ensures the door latch and hinges align properly so the oven can start and run safely
• Helps prevent heat and microwave energy leakage by restoring the intact door assembly
• Addresses symptoms such as a door that won't close, visible damage to the door, or an oven that won't start due to door switch disengagement

• One complete door assembly

• High-level replacement recommended; follow the oven manufacturer's service manual for disassembly/reassembly steps
• Disconnect power at the breaker before beginning any repair to avoid electrical shock
• Use proper tools and handle glass sections carefully to avoid breakage or injury
• If door adjustments or latch alignment are needed after installation, test operation per OEM instructions