Microwave Screws, Nuts, Washers

Replacement mounting screw for ranges and ovens. Secures panels, brackets, and internal components. Order when original screw is missing, stripped, or lost.

Speednut fastener for ranges and ovens. Secures panels and components. Replace if stripped, missing, or no longer holds parts firmly in place.

Almond screw for microwave vent grille assembly. Replace if missing, stripped, or broken. Secures the exterior grille panel to the unit housing.

Microwave mounting screw used to secure internal components or attach the unit to cabinets. Replace if screw is stripped, missing, or broken.

Replace your microwave's mounting nut if the original is stripped, missing, or damaged. Secures components during installation and ensures stability.

Replacement screw for securing panels, brackets, and trim pieces on appliances. Needed when original fasteners are stripped, missing, or damaged.

The Common Nut is an OEM part for LG ranges. It secures the fan blade to the motor shaft. This nut maintains the fan's stability and preventing it from becoming dislodged during use.

Causes of a bad common nut can include loosening over time due to vibration, improper installation, or damage from impact or mishandling.

Symptoms of a bad common nut include:

• Excessive noise or vibration from the fan assembly
• The fan blade becoming loose or detached, causing poor air circulation
• Potential risk of the fan blade becoming a projectile if completely detached

This OEM LG part is also compatible with some Kenmore models.a

This hardware washer helps distribute fastener load and maintain proper spacing in your LG appliance. Replacing a missing or worn washer restores secure mounting and alignment, reducing vibration and rattling from loose assemblies.

• Distributes the load of a screw or bolt and protects mating surfaces to maintain alignment
• Helps keep components secure and at the correct spacing
• A damaged or missing washer can lead to loosening, vibration, or rattling during operation
• Ensures correct hardware stack-up during reassembly after service

• Disconnect power and shut off water or gas before servicing
• Note the order and orientation of any washers/spacers; take a reference photo
• Use the correct driver or wrench and tighten snugly—do not overtighten
• Replace companion hardware if corroded, stripped, or damaged

Self-threading screw secures microwave panels and components. Replaces stripped, missing, or damaged screws to restore secure fits and eliminate rattles.