Kenmore Refrigerator 363.58067890 (36358067890, 363 58067890) Parts
Genuine Ge part
By: Ge
Part Number: WR60X114
Freezer not cooling or making buzzing noise? The evaporator fan blade circulates cold air. Easy DIY fix in under 5 minutes—simply pull off and press on.
Do-It-Yourself Stories from Customers like You
Broken fan blade Thomas H. • West Blocton , AL • April 21, 2014
I used a set of ring pliers to remove the old retaining ring, then spread the plastic ribs around the fan motor shaft with a small flat bladed screwdriver to ease removal of the old fan blade. I reversed the process to replace the blade, gently tapping a socket from my socket wrench set placed over the motor shaft and ribs with a small rubber mallet. I stopped when the shaft protruded about 1/8" beyond the plastic ribs of the new fan blade, then installed the new retaining clamp ring with the...
Read more
More
$17.95
- Compare At:
-
$24.40
- You Save:
-
$6.45
Genuine Ge part
By: Ge
Part Number: WR17X11349
Plastic water line that connects the water inlet valve to the ice maker. Replace if cracked, leaking, or damaged. Includes installation video.
Do-It-Yourself Stories from Customers like You
Water valve was leaking and return water line was leaking Ivan D. • Hialeah , FL • May 22, 2015
Fridge is 14 years old, ordered the water valve assembly and hose. Removed and replaced both
Read more
More
$8.95
- Compare At:
-
$10.56
- You Save:
-
$1.61
Genuine Ge part
By: Ge
Part Number: WR2X8474
Rubber grommet seals the ice maker fill tube where it enters the refrigerator cabinet. Replace if cracked, brittle, leaking, or missing to restore seal.
This part fixes the following symptoms
-
Leaking
-
Ice maker not making ice
See more...
Do-It-Yourself Stories from Customers like You
Had a cracked plastic ice maker inlet water tube that flooded part of kitchen floor Terry C. • Durham , NC • February 16, 2019
Replaced original (18 yrs.) 1/4" plastic tubing, clamp and grommet (AppliancePartsPros/GE parts) from outlet of ice maker water control valve to ice maker inlet. Also replaced water supply line to inlet of water control valve with new, GE braided, PEX 1/4" supply line with pre-attached female compression fittings on both ends. Repair job with AppliancePartsPros parts from outlet of water control valve went perfectly well, was simple, and had no leaks when tested. Parts were easy to install,...
Read more
More
$32.95
- Compare At:
-
$38.88
- You Save:
-
$5.93
Genuine Ge part
By: Ge
Part Number: WR17X4310
Ice not dispensing or slow ice flow? This ice bucket and auger assembly stores and moves ice to your dispenser. Simple DIY install in 10-30 minutes.
Do-It-Yourself Stories from Customers like You
Refrigerator automatic ice bucket had rust on the auger helix dispenser Eric B. • Burke , VA • October 15, 2014
I ordered a new bucket and auger combination--I didn't want to have to completely disassemble the mechanism to replace the rusted auger helix dispenser, so for about twice the cost of the auger alone I got the complete assembly. The product arrived in pristine condition less than 48 hours after I purchased it online. About 10 minutes later (most of that spent taking out the old bucket and finding my philips head screwdriver), I had removed the four screws holding the cover plate on the old...
Read more
More
$268.21
- Compare At:
-
$319.17
- You Save:
-
$50.96
Genuine Ge part
By: Ge
Part Number: WR60X225
Refrigerator not cooling or compressor overheating? A failed condenser fan motor is often the cause. This repair takes about 10 minutes with basic tools.
Do-It-Yourself Stories from Customers like You
Condenser fan motor failed Michael P. • Riverview , FL • November 09, 2015
Resurched the Needed part. Found Appliance parts pro had the best price. Ordered the part at 2:47pm pm on Thursday. Confirm email immedately received. Shipped email received in less then two hours. Item dropped at my door 1:00pm next day. I only paid for regular shipping. Very impressive. Great job, Thanks
Read more
More
$256.21
- Compare At:
-
$304.89
- You Save:
-
$48.68
Genuine Ge part
By: Ge
Part Number: WR07X10055
Compressor clicks on and off or won't start? This PTC start relay energizes the compressor start winding to restore consistent cooling. DIY-friendly repair.
Do-It-Yourself Stories from Customers like You
The compressor was clicking on and off refrigerator was blowing hot air inside Steve F. • Sealy , TX • May 27, 2017
I bought this relay switch and it works great. On the left side of the compressor there is a plastic cover you pry off with a screw driver. The relay switch had one wire plug on it. Just pull the wire off and the pull the relay switch off the compressor.
Read more
More
$21.95
- Compare At:
-
$25.90
- You Save:
-
$3.95
Genuine Ge part
By: Ge
Part Number: WR62X26536
Ice dispenser stuck on crushed or not dispensing? This armature kit connects the solenoid to the chute door. Moderate DIY repair with video guide.
Do-It-Yourself Stories from Customers like You
Water was overflowing out of the ice maker during fill process and freezing into a block of ice! Steven B. • Arlington , TX • March 17, 2015
Replaced the water supply valve...boom!
Read more
More
$52.73
- Compare At:
-
$63.28
- You Save:
-
$10.55
Genuine Ge part
By: Ge
Part Number: WR2X9561
Fix a light that won't turn on or flickers in your refrigerator. This E12 socket replacement is straightforward with our step-by-step video guide.
Do-It-Yourself Stories from Customers like You
Ice maker would not dispense ice and chute/container would frost over Theo S. • Tallahassee , FL • October 01, 2014
When diagnosing the problem, I discovered that the ice door was not properly sealing and that the solenoid had appeared to rust/corrode forcing the door open.
I replaced most of the ice dispenser internals (solenoid, crank, door, and spring) following the video.
The door will now open when dispensing ice (which it does!), and will oddly stay open for a few seconds once I am finished, but does seal properly and the chute/container no longer frosts over.
Read more
More
$14.39
- Compare At:
-
$16.98
- You Save:
-
$2.59
Genuine Ge part
By: Ge
Part Number: WR62X107
Ice dispenser door won't open or solenoid buzzing? This door solenoid assembly controls the ice chute flapper. Moderate DIY repair with video guide.
Do-It-Yourself Stories from Customers like You
When dispensing ice from the ice maker, the solenoid was buzzing loudly. It was also rusting badly. Brian B. • Hudson , NH • March 28, 2014
I ordered a new solenoid and when it arrived, I installed it as follows: I cut the power to the refrigerator. I then pulled off the rubber boot (and it's plastic frame) that covers the water switch. Then I removed the bezel that covers the front of the ice maker controls by pulling it straight out. Then I removed the four screws found on the assembly under the bezel. After pulling the assembly forward a bit, I detached the multi-wire connector attached to it and put the assembly aside....
Read more
More
$74.34
- Compare At:
-
$88.46
- You Save:
-
$14.12
Genuine Ge part
By: Ge
Part Number: WR87X20798
Refrigerator not cooling or compressor clicking on and off? This compressor kit restores cooling. Requires certified technician with specialty tools.
More
$437.76
- Compare At:
-
$520.93
- You Save:
-
$83.17
Genuine Ge part
By: Ge
Part Number: WR2X8818
Secures the ice chute flapper in your refrigerator door. Replace if cracked or missing to restore proper sealing and prevent frost buildup. Verify fit.
Do-It-Yourself Stories from Customers like You
Water line in door kept freezing. Charles N. • Mcdonough , GA • October 15, 2017
Replaced springs, flapper assembly and ice door retainer as described in videos and it was easy. So far so good..water dispenses.
Read more
More
$7.37
- Compare At:
-
$8.36
- You Save:
-
$0.99
Genuine Ge part
By: Ge
Part Number: WR60X10262
Ice dispenser not working or making humming noise? This auger motor drives the crusher mechanism to feed ice through the chute. Moderate DIY repair.
Do-It-Yourself Stories from Customers like You
Needed new ice maker motor and circuit board Edward Z. • Berlin , CT • August 19, 2016
I watched the help videos first, then ordered the parts, and installed all items as in the video.
Read more
More
$146.95
- Compare At:
-
$174.58
- You Save:
-
$27.63
Genuine Ge part
By: Ge
Part Number: WR23X10300
Supplies electrical power from wall outlet to refrigerator. Replace this cord if cut, frayed, overheated, or damaged to restore safe electrical connection.
Do-It-Yourself Stories from Customers like You
Power cord needed to be replaced Jorge V. • Tucson , AZ • November 14, 2015
Spliced new and old power cord near the connections in the fridge and connected them. Didn't mess with the factory harnesses or connections inside actual fridge.
Read more
More
$22.35
- Compare At:
-
$26.82
- You Save:
-
$4.47
Genuine Ge part
By: Ge
Part Number: WH2X930
Black hex washer screw for securing range components like door trim, control panels, and internal brackets. Replace missing or stripped screws during repairs.
Do-It-Yourself Stories from Customers like You
Oven door trim rusted Gladys R. • Weston , FL • August 08, 2016
I ordered the part and was impressed to receive it within two day! I didn't need the screws I ordered (which I ordered just in case) but the trim was put on with no problem and my oven looks brand new again! Thank you!
Read more
More
$11.74
- Compare At:
-
$14.09
- You Save:
-
$2.35
Genuine Ge part
By: Ge
Part Number: WR01X10618
Mounting screw fastens panels, brackets, and trim in refrigerators, dishwashers, and ranges. Replace missing, stripped, or rusty screws to secure parts.
Do-It-Yourself Stories from Customers like You
Not getting crushed ice Mike S. • Glendale , AZ • March 16, 2020
New parts.
Read more
More
$7.37
- Compare At:
-
$8.36
- You Save:
-
$0.99
Genuine Ge part
By: Ge
Part Number: WR2X4754
Secures water and drain tubing to prevent leaks, noise, and vibration. Replace if loose, cracked, or missing. Confirm fit with your model number.
Do-It-Yourself Stories from Customers like You
Had a cracked plastic ice maker inlet water tube that flooded part of kitchen floor Terry C. • Durham , NC • February 16, 2019
Replaced original (18 yrs.) 1/4" plastic tubing, clamp and grommet (AppliancePartsPros/GE parts) from outlet of ice maker water control valve to ice maker inlet. Also replaced water supply line to inlet of water control valve with new, GE braided, PEX 1/4" supply line with pre-attached female compression fittings on both ends. Repair job with AppliancePartsPros parts from outlet of water control valve went perfectly well, was simple, and had no leaks when tested. Parts were easy to install,...
Read more
More
$6.95
- Compare At:
-
$8.36
- You Save:
-
$1.41