Samsung Refrigerator RFG237ACRS Parts

Ordered the two motors plus ordered the fan blades since I was afraid one might break during replacement. Changed out without breaking Freezer and both ice makers now working fine Read more

Replaced sensors and heater element. We'll see if that fixes the problem. It usually happens every 3 months. Read more

First, I modified old butter knife by bending a 90° angle about 3/4" from the tip. I slid the bent in up under the bottom of the switch cover and worked it to one side. I then rotated the knife downward using the bent end to pry the cover off. The switch is held by plastic arms on each side. The bottom right arm has a locating pin that fits into the switch. Unplugged the switch and re-installed. Read more

I was able to find the shelves through Appliance parts website. I ordered the parts one day and they were delivered the next and I did not pay for one day shipping. One of the shelves was broken. I contacted Appliance parts by phone and spoke with Tina. She was very helpful and pleasant. I received the replacement in two days. I will definitely buy here again. Read more

• Not dispensing water

Watched video and replaced ice maker and water valve. Both very easy thanks to the video. Thanks Appliance Parts Pro's Read more

• Noisy

I bought new parts, motor and fan. Replace the old one. Took me no more than 15 minutes to fix it. Read more

In order it SHOULD be done: Pried off two white caps covering the screws that attach the flap to the left door, then removed screws. Lifted flap up to remove from door and disconnected cable. Used a thin blade to pry out the inner cover of the flap, then carefully pried out the insulation piece inside. Loosened the screw holding the center cap from the inside and removed cap. Worked the cable out of the hinge piece so it could be removed and cable pulled through case. Pried upper and lower caps... Read more

Samsung does not make it easy to replace the casters. The shafts holding the casters are crimped at the ends and had to be cut off with little room for any tools. I had to jack up the fridge and I used a hacksaw blade with a handle to cut through the wheel shafts. I didn't want to use a reciprocating saw. I couldn't find a way to crimp the new shafts so I drilled small holes at the ends and used cotter pins to retain the shafts in place.The rear caster had no room to slide the new one in... Read more

• Frost buildup
• Doesn't shut off

Ordered parts, defrosted refrigerator, and replaced with new items. This problem has been going on quite some time, while Samsung refused to acknowledge the defective unit, claiming it was owner fault. The defrosting had to be completed every 3-4 months and managed in time to require defrosting every few days. Originally a repairman came and although he defrosted it the first time, he informed us, this is quite common and the unit is defective by design; which is why we continued to defrost on... Read more

1. Viewed YouTube video twice to learn how to change out the Samsung ice maker 2. Followed the instructions So easy to do yourself. I would not spend anytime hiring someone to replace this part for you. Read more

I replaced the control board and the microswitch. Read more

Order a new fixer Read more

Samsung does not make it easy to replace the casters. The shafts holding the casters are crimped at the ends and had to be cut off with little room for any tools. I had to jack up the fridge and I used a hacksaw blade with a handle to cut through the wheel shafts. I didn't want to use a reciprocating saw. I couldn't find a way to crimp the new shafts so I drilled small holes at the ends and used cotter pins to retain the shafts in place.The rear caster had no room to slide the new one in... Read more

I looked at the blow up drawing to figure out what parts I might need. I then watched a you tube video to see how to take the handle off. I kind of figured out on my own how to remove the ruined cap handle. It took me a few minutes to figure it out and more time to remove both the handle and the broken part. Turns out I did not need the spring nor the shaft cap handle. Very proud of myself. Saved a huge amount of money. Only problem was that I could only put in one screw as the previous... Read more

Ordered tank and heater, installed, so far so good. Thanks for the speedy order Roman Read more

Ordered tank and heater, installed, so far so good. Thanks for the speedy order Roman Read more