Range / Cooktop / Oven Bracket & Flange

Motor mounting bracket for electric ranges. Secures the convection fan motor assembly. Replace if bent, cracked, or missing to properly support the motor.

Thermostat mounting bracket for ranges and ovens. Secures the thermostat sensor to the oven cavity. Replace if bent, broken, or missing hardware.

Mounting bracket for range broil element in main oven. Replace if cracked, broken, or missing to properly secure the broil element in position.

A small chassis knockout protector that shields wiring and components where factory knockout holes are removed. Helps prevent wire abrasion and keeps openings tidy for safe appliance operation. What it does:

• Fits into a chassis knockout to protect wiring from sharp sheet-metal edges
• Helps prevent cable chafing and short circuits by covering exposed openings
• Keeps out debris while allowing routed harnesses to pass through the cabinet
• Commonly used where service or modifications require a sealed knockout

• One chassis knockout protector

• Install by pressing the protector into the knockout until it seats securely
• Ensure wiring is routed through the protector and not pinched between metal edges
• Disconnect power before servicing appliance to avoid shock or injury

Mounting bracket for wall oven hi-limit thermostat. Secures thermostat in proper position. Replace if bent, broken, or missing to ensure safe installation.

A replacement mounting bracket that secures internal components or panels so parts stay aligned and stable during normal use. Restores proper fit and reduces movement that can cause rubbing or noise. What it does:

• Supports and holds a panel, assembly, or component in the correct position
• Prevents shifting that can lead to rattling, misalignment, or premature wear
• Provides a fixed attachment point for fasteners or clips
• Helps maintain proper gap and alignment for doors or covers

• Disconnect power and water before starting repairs
• Inspect surrounding fasteners and clips; replace any that are damaged
• Use basic hand tools; follow OEM diagram for orientation and screw locations

Secures burner tubes to the range frame. Replace this metal mounting bracket if it's bent, broken, or corroded, causing tubes to shift or sit improperly.