Range / Cooktop / Oven Support Parts

Latch plate with mounting screws for your range. Replaces a broken, cracked, or missing latch plate to restore proper door latching functionality.

Elbow plate for ranges. Mounts to the burner assembly to provide structural support. Replace if bent, cracked, broken, or missing for proper fit.

Replace your range control mount plate if it's cracked, broken, or missing. This structural plate secures and supports control panel components inside the range.

This support relay board controls power switching for key refrigerator components, restoring reliable operation of compressors, fans and other powered circuits. It replaces a failed relay board to help get your appliance running properly again. What it does:

• Switches power to compressors, fans and other major components via relays
• Re-establishes reliable electrical control when relays stop responding
• Can resolve symptoms such as components not receiving power, unit not cooling, or intermittent operation
• Works as the circuit-level interface between the main control and high-current components

• Disconnect power to the appliance before accessing or replacing the board
• Handle the board carefully to avoid ESD; avoid touching components or exposed contacts
• Use basic hand tools to remove protective panels and mounting hardware

This right-side outer support glass is the oven door glass component that helps stabilize the door assembly and maintain a finished exterior. Replacing damaged support glass restores proper door alignment and reduces drafts, rattles, and heat escape. What it does:

• Provides structural support for the oven door outer glass panel on the right side
• Helps keep the door aligned for smooth opening and closing
• Reduces air and heat leakage that can occur with damaged or loose glass supports
• Stops rattling or vibration caused by a cracked or broken support

• Disconnect power to the appliance before beginning any repair.
• Handle glass carefully and wear cut-resistant gloves and eye protection.
• Removal typically requires taking the oven door off and removing retaining screws; keep fasteners organized.

This support outer glass is the OEM replacement piece that secures and protects the outer oven door glass for the left-front position. Restores proper door fit and helps maintain safe, even heat containment. What it does

• Holds and stabilizes the outer glass panel in the oven door assembly.
• Prevents glass movement or rattling during use.
• Helps maintain proper door alignment and seal to reduce heat loss.
• Commonly replaced when cracked, warped, broken, or when glass no longer sits flush.

• One support outer glass (left-front) as pictured.

• Disconnect power to the appliance and allow all surfaces to fully cool before beginning.
• Handle glass carefully and wear cut-resistant gloves and eye protection.
• Door removal or partial disassembly is often required; follow the oven's service manual for safe removal procedure.