Range / Cooktop / Oven Support Parts

Reflector plate for ranges. Installs beneath burners to direct heat and protect components. Replace if cracked, warped, discolored, or missing.

This plate is a flat mounting plate used to secure internal components and assemblies on compatible Frigidaire appliances. It provides a stable attachment point to keep parts aligned and reduce vibration for reliable operation. What it does:

• Serves as a mounting/support plate that fastens appliance components in place
• Helps keep moving parts aligned to prevent rattling or misalignment
• Restores secure attachment when a worn or damaged plate causes loose panels or parts
• Commonly used where a flat bracket or support is required inside the appliance

• Disconnect power (unplug appliance or shut off circuit breaker) before starting any repair
• Remove surrounding panels as needed to access the mounting location; keep hardware for reuse unless damaged
• Reuse original screws if in good condition; replace stripped or damaged fasteners

This instrument mounting plate secures the appliance control or instrument cluster inside the cabinet, keeping electronic components aligned and stable for reliable operation. It helps restore proper fit and prevents movement that can cause noise or poor connections. What it does:

• Provides a firm mounting surface for the control board or instrument cluster
• Keeps connectors and wires properly positioned to maintain electrical connections
• Reduces vibration and rattling from loose or damaged mounting points
• Restores alignment so buttons, displays, and knobs operate correctly

• One instrument mounting plate

• Disconnect power before starting any repair to avoid electrical shock
• Retain or reuse original screws unless replacements are specified; verify screw sizes before installation
• Handle edges carefully; mounting plates may have sharp edges
• Check alignment and connector seating before reassembling the cabinet panels

Support plate that secures the burner tube assembly in your range. Replace if cracked, warped, or corroded to properly mount and stabilize burner components.

Mounting plate for electric and gas ranges. Secures components in place. Replace if cracked, bent, or broken to restore proper structural support.

This channel burner support is a stamped support bracket designed to hold and align the range burner channel and related components so burners sit correctly. It helps restore proper fit and stable burner operation. What it does:

• Secures the burner channel and keeps burners aligned for consistent heating
• Prevents wobbling or misalignment of the burner assembly during use
• Helps maintain correct spacing between burner components and gas valve/manifold
• Commonly replaced when the original support is bent, cracked, or damaged

• One channel burner support bracket

• Designed to mount with existing fasteners; inspect screws or clips and replace if worn
• Turn off power and gas supply (for gas ranges) before servicing; follow appliance safety procedures
• Handle sharp edges carefully; wear gloves to avoid cuts

This replacement channel is the support bracket that guides and stabilizes a refrigerator drawer or shelf, helping keep components aligned for smooth opening and closing. Use it to replace damaged or worn channels. What it does

• Guides and supports a drawer or shelf to maintain proper alignment
• Reduces sticking, binding, or uneven drawer movement
• Helps eliminate rattling or excessive play in the drawer/shelf assembly
• Restores the intended fit of the drawer/shelf to prevent gaps or misalignment

• One channel

• Disconnect power to the appliance before starting any repairs
• Remove the drawer or shelf per the appliance disassembly steps to access and replace the channel
• Inspect mounting tabs and fasteners; replace any damaged clips or screws as needed