Range Fuse Or Sensor

This safety thermostat is a temperature-limiting switch that helps protect the refrigeration system by cutting power if operating temperatures exceed safe limits. Replace a failed unit to restore the appliance's built-in over-temperature protection. What it does:

• Monitors internal system temperatures and opens the circuit when temperatures rise above a safe threshold
• Stops the compressor or heating element to prevent overheating-related damage
• Helps reduce risk of component failure caused by excessive operating temperatures
• Common symptom: appliance runs but cooling is inconsistent or compressor cycles abnormally
• Suitable as the OEM safety thermostat replacement for compatible Frigidaire units

• Always disconnect power before servicing the appliance
• Locate thermostat per the appliance wiring diagram; may be mounted on compressor, evaporator housing, or control assembly
• Handle terminals and wiring carefully; ensure secure, correct reconnections

This thermostat senses appliance temperature and helps the control maintain proper cooling. It replaces a failed temperature switch to restore reliable temperature regulation and protect components from overheating. What it does

• Monitors temperature and signals the control board or compressor to turn cooling on or off
• Prevents overheating by opening the circuit when temperatures exceed safe limits
• Commonly replaced when the appliance does not reach or maintain the correct temperature
• Can stop intermittent cooling or continuous-run symptoms when the original thermostat fails

• One thermostat as shown

• For experienced DIYers only; disconnect power before servicing
• Follow manufacturer instructions and verify correct part placement and wiring before restoring power
• Do not modify the part; use proper tools and replacement hardware

This fixed thermostat monitors and helps regulate appliance temperature to maintain safe operation and reliable cooling/heating. It replaces a worn or failed thermostat to restore proper cycling and temperature control. What it does:

• Opens or closes a circuit at a set temperature to control heating or cooling cycles
• Prevents continuous run by signaling the system to stop when the desired temperature is reached
• Commonly used to address symptoms like no temperature control, compressor or heater running nonstop, or failure to reach set temperature
• Works as a safety/control device to reduce risk of overheating when operating correctly

• One fixed thermostat

• Disconnect power before servicing to avoid shock or injury
• Locate and access the thermostat per your model's service instructions (typically mounted near the evaporator, heater, or air path)
• Handle carefully and avoid bending or damaging terminals; verify function with a multimeter if equipped