Parts for Speed Queen ATEE9ASP175TW01: Rear Bulkhead / Felt Seal / Cylinder Roller / Terminal Block Parts

Washer adhesive is a clear sealant used to secure various internal components and create watertight seals within the washing machine. Use this adhesive when experiencing water leaks, loose parts, or when replacing gaskets and seals during repairs.

Seals the gap between drum and bulkhead to reduce air leaks, prevent lint buildup, and quiet operation. Replace if torn or worn. Adhesive required.

This seal kit includes felt seals designed for use in residential dryers manufactured from 1992 onward. The felt seals sit between the drum and the dryer housing to prevent heated air and lint from escaping the drum cavity. Replace this kit if you notice excessive lint buildup outside the drum area, longer drying times, or unusual squeaking and scraping noises during operation.

Replaces missing or damaged 10B-16 x 0.34 inch cabinet screw. Secures panels, brackets, and covers. Restores tight fit to reduce vibration and rattles.

This rear bulkhead assembly provides the rear tub support and a watertight seal to keep washer water contained and flowing correctly. It replaces a damaged or leaking rear housing to stop rear leaks and restore proper tub alignment. What it does:

• Seals the rear of the inner tub to prevent water from leaking at the back of the washer
• Supports and aligns the tub to help maintain smooth spinning and prevent rubbing
• Directs drain and rinse water flow toward the pump and drain path
• Helps reduce water dripping onto the cabinet floor or rear-facing components

• Disconnect power and turn off water supply before beginning any repairs.
• Typical access requires removing the washer top or rear panel; follow the OEM service manual for your model.
• Inspect surrounding gaskets, hoses, and fasteners for wear and replace if needed.
• Ensure the sealing surface and lip are clean and fully engaged during reassembly to prevent leaks.

Seals the back of the dryer drum to prevent air leaks and maintain proper alignment. Replace if you notice poor drying or air escaping. Confirm fit with your model.

Self-tapping hex washer head screw secures plastic trim and sheet-metal panels on dryers. Replace worn, stripped, or missing screws during repairs.

Dryer not powering on or overheating at the power connection? This terminal block assembly restores safe electrical connections. Moderate DIY repair.

If your dryer is vibrating excessively or making loud thumping noises, a worn drum roller bracket may be the cause. This bracket restores smooth rotation.

This drum support roller installs inside your dryer to support and guide the drum as it rotates. Replace if cracked, worn, or causing noise during operation.

This wave washer is a spring-style spacer used in washer assemblies to apply tension and maintain proper spacing. It controls endplay so parts fit securely and the machine runs smoothly with reduced vibration and noise during wash and spin cycles.

• Provides spring preload to maintain correct spacing in rotating assemblies
• Helps limit endplay that can cause rattling, chatter, or intermittent engagement
• Can help address symptoms like metallic noises, excessive play/wobble, or rough operation during agitation or spin
• Replace if the original washer is flattened, cracked, or missing

• Disconnect power and turn off water before servicing
• Note the exact stack order and orientation of spacers/shims during disassembly
• Install the new wave washer in the same orientation; do not bend or deform it
• Reassemble and hand-rotate components to check for smooth operation before test-running

Threaded metal shaft that mounts the idler roller in dryers and washer-dryer combos. Replace if bent, worn, or stripped threads prevent secure roller installation.

Drum roller kit for Speed Queen dryers (1992-newer). Includes rollers and axles that support smooth drum rotation. Replace when worn or broken.