Parts for Speed Queen ATEE9ASP175TW01: Inner Basket / Trunnion / Bearing Housing / Pulley Parts

This balance ring assembly helps stabilize the washer tub and reduce vibration and excessive movement during spin cycles. Replacing a worn or damaged balance ring restores quieter, more even operation. What it does:

• Cushions and balances the outer tub to reduce vibration and rocking during spin
• Helps prevent loud banging or thumping noises caused by an unbalanced load
• Reduces wear on suspension components by keeping the tub properly centered
• Contributes to smoother spin performance and more consistent draining

• Disconnect power and water before beginning any repairs
• Handle tub components carefully—use proper supports to prevent the tub from shifting or falling

Replacement Cobra-style lifter for top-load washers. Restores proper vertical movement and alignment of the tub/agitator assembly so the washer can agitate and spin more effectively. What it does:

• Raises and centers the inner tub/agitator assembly to maintain correct wash action
• Transmits vertical motion between the transmission/drum and the agitator/tub
• Commonly replaced when wear causes poor agitation, excessive vibration, or noisy operation
• Helps prevent rubbing or binding that can lead to uneven loads or premature component wear

• Disconnect power and water before starting any repair
• Follow the manufacturer service manual for disassembly and reassembly procedures
• May require partial cabinet or basket removal and basic hand tools

This trunnion shaft and hardware kit restores the washer tub support and connection to the drive assembly, helping reduce tub wobble and noisy operation while re-establishing proper rotation and alignment. What it does

• Replaces the worn or damaged trunnion shaft that supports and centers the wash basket/tub.
• Restores secure connection between the tub and drive, reducing vibration and wobble during spin.
• Addresses symptoms such as excessive noise, uneven spinning, or tub misalignment.
• Works with the washer's existing seals and bearings when those components are serviceable.

• Disconnect power and water before servicing; follow all safety guidelines.
• Tub may need to be supported or partially disassembled to access and remove the old shaft.
• Inspect related seals, bearings, and fasteners during replacement; replace any worn parts to prevent premature failure.
• Use correct torque and alignment during reassembly.

This is a stainless-steel #8 x 1/2" Torx screw used to secure panels and components on Speed Queen appliances. Stainless construction resists corrosion for reliable fastened connections in laundry equipment. What it does

• Secures console, trim, panels, and internal brackets where a #8 x 1/2" Torx fastener is specified.
• Replaces missing or damaged screws that can cause loose panels, rattling, or misaligned components.
• Stainless-steel construction helps prevent rust in wet or humid laundry environments.
• Small, common fastener for service and reassembly after repairs.

• One stainless-steel #8 x 1/2" Torx screw.

• Use the correct Torx driver size to avoid stripping the screw head.
• Tighten finger-tight then snug; avoid over-torquing which can strip threads or crack plastic.
• Disconnect power (and water if applicable) before working on appliance internals to reduce shock or injury risk.

This bearing housing and hub kit replaces the tub support assembly that holds the inner tub in place, restoring smooth rotation and reducing noise and vibration. Ideal when worn bearings or a damaged hub cause rumbling or wobble. What it does:

• Supports the inner tub and secures the hub for proper drum rotation
• Replaces worn bearing surfaces that cause loud noise or rough spinning
• Helps stop wobble or uneven tub movement linked to failed bearings/hub
• Restores correct alignment to reduce stress on the drive system

• Disconnect power and water supply before beginning work
• Support the tub and follow service manual steps; disassemble top/front panels as required
• Inspect related seals and bearings; replace damaged seals to prevent leaks