Refrigerator Bracket & Flange

This mounting bracket secures and supports an appliance component—commonly used to hold an ice maker or related assembly in place—helping prevent movement and alignment issues for reliable operation. What it does

• Provides a stable mounting point to keep the ice maker or nearby component fixed in position
• Helps maintain proper alignment so actuators and water paths operate correctly
• Reduces vibration and rattling caused by a loose assembly
• Can prevent intermittent contact or misfeeds caused by a shifted component

• One mounting bracket

• Disconnect power and water supply before beginning work
• Requires basic hand tools (screwdriver, nut driver) and careful removal of interior panels
• Inspect surrounding clips, screws and wiring for damage before reassembly
• Handle sharp sheet-metal edges with care and secure fasteners after installation

This freezer tower lower bracket secures the lower portion of the freezer air/tower assembly to the cabinet so the tower stays stable and aligned for proper airflow and operation. Replaces a worn, cracked, or broken lower support bracket to reduce tower movement. What it does

• Secures and supports the lower section of the freezer air/tower or trim assembly
• Prevents the tower from shifting, which can cause noise, poor airflow, or misalignment
• Helps maintain proper airflow paths inside the freezer for consistent cooling
• Restores stable mounting after the original bracket becomes cracked, bent, or broken

• One lower freezer tower support bracket

• Disconnect power to the appliance before starting any repair
• Typical install requires removing interior panels and sliding the tower into position; basic hand tools like a screwdriver may be needed
• Handle sharp sheet-metal edges and wear gloves
• If fasteners are damaged or missing, replace them with OEM-specified screws

This ice maker mounting bracket secures the refrigerator ice maker in place so it stays properly aligned for reliable ice production. It replaces worn or damaged support hardware to reduce movement and prevent misalignment. What it does

• Secures the ice maker assembly to the freezer cabinet to keep it stable during operation
• Helps maintain proper alignment for the ice mold and fill valve to reduce improper fills
• Can stop excessive vibration or rattling caused by a loose ice maker
• Addresses symptoms such as a shifting or sagging ice maker, noisy operation, or intermittent ice production

• Disconnect power (and water if applicable) before beginning any service.
• Basic hand tools (screwdriver or nut driver) are typically required to remove and install the bracket.
• Inspect mounting screws and surrounding components; replace any damaged fasteners.