Refrigerator Lever Parts

This replacement pad cushions and isolates appliance components to reduce vibration, protect parts from metal-on-metal contact, and help prevent wear. It's a small but important part for quieter, smoother operation. What it does:

• Cushions components to reduce vibration and rattling during operation
• Prevents direct contact that can cause wear or chipping of adjacent parts
• Helps maintain proper alignment of panels or assemblies that use a soft support
• Can reduce noise caused by loose or worn mounting interfaces

• One replacement pad

• Inspect the mounting area and replace any damaged clips or fasteners before installing
• Clean mating surfaces so the pad seats fully and adheres
• Install with appliance powered off and following any disassembly steps in your service manual

This air damper actuator is the motorized control that opens and closes the refrigerator air damper to regulate airflow between compartments, helping maintain even temperatures and proper cooling performance. What it does:

• Rotates the damper door to direct cold air into the refrigerator or freezer compartments
• Helps balance compartment temperatures for food safety and efficiency
• Can prevent overcooling or warming when functioning correctly
• Failure symptoms may include uneven temperatures, reduced cooling, or a damper that won't open/close

• Disconnect power to the appliance before starting any work
• Typically mounts to the damper housing with screws and connects to a wiring harness; verify harness alignment before reconnecting
• Handle the actuator and damper door gently to avoid damage to the gear teeth

This wire actuator engages the refrigerator dispenser paddle to activate water or ice dispensing. It restores reliable mechanical actuation for responsive dispenser operation without replacing the entire dispenser assembly. What it does:

• Translates paddle movement into the dispenser switch action so water or ice starts when the paddle is pressed
• Helps correct a dispenser that doesn't activate when the paddle is pushed
• Replaces a bent, broken or worn actuator wire that can cause inconsistent dispensing
• Works with the dispenser lever and switch assembly to restore proper alignment and motion

• Includes: 1 wire actuator for dispenser

• Disconnect power (unplug or shut off breaker) and turn off the water supply before starting
• Remove dispenser trim/paddle to access and replace the actuator; avoid forcing plastic clips
• Verify alignment with the dispenser switch and paddle during reassembly to prevent binding

A replacement dispenser wire actuator that engages the door-mounted water/ice dispenser when pressed, restoring reliable lever operation and user control at the refrigerator door. Matches OEM form and function for dispenser activation. What it does

• Transfers user pressure from the dispenser lever to the valve/actuator assembly so water or ice is dispensed.
• Replaces bent, broken, or loose actuator wire that causes intermittent or no dispensing.
• Helps restore a positive lever feel and consistent dispenser response.
• Safe, low-voltage mechanical linkage — not an electrical control.

• One dispenser wire actuator (single lever wire).

• Unplug or disconnect refrigerator power before beginning any repair to avoid electrical hazard.
• Basic door panel removal may be required; handle trim and clips carefully to avoid damage.
• Align the wire with the dispenser lever and secure per OEM mounting—do not force or bend excessively.