Your privacy choices: We and our partners use cookies for analytics and ads. Decline all turns them off.
Privacy Policy · Do Not Sell or Share My Personal Information
Need Help?
Call
Replace cracked or missing compression fitting inserts for 1/4-inch water tubing in refrigerators and ice makers. Prevents leaks at connections.
This is an electromechanical defrost timer that controls the automatic defrost cycle in a refrigerator. It periodically switches the compressor off and activates the defrost heater to melt frost buildup on the evaporator coils. Replace this timer if your refrigerator is not defrosting properly, frost is building up excessively on the back wall of the freezer, or the compressor runs continuously without cycling into defrost mode.
I replaced the Thermostat and Defrost Timer. It was a fairly easy repair other than removing the old Defrost Timer. The way the manufacturer, in this case, Amana, mounts that unit with "clips" is just poor design and engineering. It is virtually impossible to get the timer out without damaging the mounts. I had to do some creative rework to mount the new timer. After 2 days, the fridge appears to be working properly with these new parts. The new parts were shipped Very Fast...APP is... Read more
This power cord connects your appliance to household electricity, supplying safe, reliable power to its controls and components. Replace a damaged or overheated cord to restore dependable operation and reduce the risk of shorts.
Thanks to you, all went well. No problems. Read more
Ice maker not cycling or shutting off? This control arm extension restores proper movement to the ice maker mechanism. Simple snap-in replacement.
Fridge clicks or hums but won't cool? A failed start relay prevents the compressor from starting. Simple DIY repair—just pull off and replace.
Used a muiltimeter to test all parts and ohm'ed out all parts. found out condenser fan motor seized up [open winding in motor] replaced that, and found that also caused the compressor overload and relay to fail, from over heating and over cycling, replaced both parts, powered up the refrigerator retested all electrical parts checked amp reading on all parts under load conditions,works good know, hope to get another 15 years out of this refrigator, its a maytag. over 20 years old. Read more
Heat-resistant fiberglass gasket seals your oven door perimeter to maintain consistent temperatures. Replace when worn, frayed, or flattened to restore efficiency. Verify fit by model number.
This defrost thermostat with attached wiring harness monitors the evaporator coil temperature and signals the defrost heater to turn on or off during the defrost cycle. It is typically mounted on or near the evaporator coils inside the freezer compartment. Replace this part if the refrigerator is not cooling properly, frost is building up excessively on the evaporator coils, or the defrost cycle is not functioning correctly.
Replaced the heater, timer, and wiring harness Read more
This is a small white plastic plug that fills the hinge sleeve hole on a refrigerator or freezer door. It covers unused hinge mounting holes to provide a clean, finished appearance, especially after reversing the door swing. Replace this plug if it has cracked, fallen out, or gone missing, leaving an exposed hole in the door.
Took off the freezer door, took off the top hinge on the refrigerator door, replaced the handle, re-installed the top hinge and the freezer door. This is a two person job - one to remove the top hinge and replace the handle, while a second person holds the refrigerator door in place. Replacing the handle was easy. The most irritating part was figuring out what parts to order. The drawing of the refrigerator door (Drawing # 4) used to figure out what parts to order was not clear. I paid $8... Read more
Supports and pivots the hinged dryer top panel for service access. Replace if cracked, broken, or causing wobble, scraping, or alignment gaps.
Replaced belt and idler arm, just to be safe. Read more
Refrigerator not cooling or compressor running hot? This start device kit includes relay and overload to restore proper compressor function. DIY install.
I suspected the start-relay and tested it due to the lint plugged condenser coils. The start-relay rattled when shook, a telling sign it is no good due to over heating. I tested the compressor terminals and compared them the results with the Tech Data Sheet found with the unit, to find my compressor was still good. I checked the start capacitor with a capacitor tester, comparing the results with the rating printed on the side of the capacitor and found it to be good. I cleaned the condenser... Read more
Door hinge butt for top-mount refrigerators. Mounts between cabinet and door to support hinge pin assembly. Replace if cracked, broken, or worn out.
Looked at web site, but I was not sure I was ordering the correct parts. I did an on line chat . It was great only 3 minutes and I had the parts on the way . Super easy . Needed door hinge. Read more
Two 5-foot nylon braided hoses connect household water supply to washer inlet valves. Replace cracked, leaking, or aging hoses to prevent water damage.
Watched u tube video. Ordered replacement water inlet valve and new hoses. Dismantled washer and replaced defective valve and installed new hoses. The repair went very easily and the washer worked perfectly as a result. Read more
Cushioning pad that installs between the washer lid hinge and cabinet. Replace if cracked, worn, or missing to reduce squeaks and prevent metal wear.
Removed the screws, lifted the old lid out of the hinges. Replaced the hinges, set new lid in the hinges and replaced screws. Read more
Contains two, six foot long braided hoses with 90 degree ends.
I had a problem with the drain pump on my Kenmore HE3 and I replaced it using a drain pump I ordered from APP. That fixed that problem but once I started running the washer I started getting a FH error code. I looked it up and found that it was a problem with the washer not filling properly. I pulled the washer out and found that one of the fill hoses had kinked when I pushed the washer back in place. There was also some writing on the hose that read "Change hose every five years". I know I had... Read more
Fix a refrigerator that won't cool or runs constantly. This temperature control thermostat cycles cooling based on compartment temperature. DIY fix in 15-20 min.
I determined it was the thermostat, found the model number and Appliance Pros had one they said would work. So, I ordered one and got it in 2 days. Opened the package, read the instructions and 10 minutes later my new food was going to be cool and my water would be ice. All it took was remove housing, unplug old part, plug in new part and replace housing. Read more
Replaces burned-out, dim, or flickering refrigerator light bulbs to restore clear interior visibility. Easy DIY installation—just unscrew old bulb and install new one. Verify fit by your model number.
I'm way too lazy to go to a store and look at a gigantic wall of light bulbs. So I poured a glass of wine, googled the make and model of my refrigerator followed by "lightbulb" and this bulb came up. If you're tracking the full length of this project you'll be interested to note that I held up the bulb for roughly 3 seconds to conclude it was the right one. *don't drink too much wine before this part. I counted the bulbs in my fridge/freezer (also do this before too much wine) and decided I... Read more
Opt-Out Request Honored
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.