Roper Screws, Nuts, Washers

This is a replacement 8-18 x 7/32 machine screw used to secure panels and small components in compatible Whirlpool appliances. It restores proper fastening where a screw is missing, stripped, or damaged. What it does:

• Secures panels, trim pieces, brackets or small components to prevent movement
• Helps stop rattling, vibration noise, or loose-fitting parts
• Replaces missing or damaged screws to restore proper alignment of panels or controls
• Used wherever an 8-18 x 7/32 machine screw is specified by the manufacturer

• Unplug the appliance or turn off power before servicing.
• Use the correct screwdriver or bit to avoid stripping the head; tighten snugly but do not over-torque.
• Replace any stripped inserts or mating hardware if threads are damaged.

This is a replacement screw used to secure appliance parts and panels. It restores proper fastening where the original screw is missing, stripped, or corroded. What it does:

• Secures panels, brackets, or components in place to maintain appliance alignment
• Replaces lost, damaged, or rusted fasteners for a reliable hold
• Helps prevent rattling or movement caused by a missing screw
• Works wherever the OEM screw specification and fit match

• One screw

• Use the matching screwdriver or driver bit; avoid overtightening to prevent stripping
• Disconnect power and follow appliance safety precautions before servicing

This block restraint is a small mounting block that secures internal components and limits movement to reduce noise and wear. It restores proper alignment and keeps parts from shifting during operation. What it does:

• Anchors and stabilizes nearby components to prevent excessive movement and vibration
• Helps reduce rattling or banging noises caused by loose internal parts
• Keeps parts aligned to prevent premature wear or abrasion
• Supports safe, reliable operation by holding components in the intended position

• One block restraint

• Disconnect power (and water for washers/dishwashers) before beginning any repair
• Access the mounting location by removing the appropriate panel(s); basic hand tools typically required
• Remove the old block and replace with the new restraint; ensure correct orientation and secure fit
• Inspect surrounding fasteners and mounting surfaces; do not overtighten plastic parts

Package of 12