Roper Spray Arm & Related

• Not cleaning dishes properly

I called to ask about the correct gasket for the door. As VERY helpful lady suggested that it was probably a split arm spray. She was absolutely correct. I have used you web site for parts in the past and will always make it my first stop when ordering appliance parts. Read more

My discharge would not empty after a wash cycle and I always had gross gray water left in the bottom approx 3" deep? After doing the obvious things of checking the simp for garbage, and checking that the discharge hose wasn't blocked, I removed my discharge pump ( not too hard to do) and tested. My pump which did run and turn the impeller. However, the pump evidently had weakened with time and weakened and could no longer pump the waste water up hill to the "T" connection under the sink. A... Read more

Replaced upper and lower spray arms, plus nylon bearings. Read more

• Not cleaning dishes properly

Replaced upper and lower spray arms, plus nylon bearings. Read more

Removed 8 hex screws and the cap to remove the broken threads...used needle nosed pliers for this, stuck them in and expanded them to put pressure on the thread sleeve from the inside, as threads were broken off below the edge. Replaced all very simply Read more

We initially noticed the dishwasher running loud and failing to completely clean dishes. Research suggested issues like this were normally caused by either the main circulation motor or the drain motor. Over the next week the noise worsened, and it became obvious that the circulation motor had went (loud whirring noise whenever the spin cycle kicked in). I watched a couple youtube videos on the removal and dissassembly until I felt confident that my wife and I could handle the project. For the... Read more

We bought replacement parts from you and my daughter fixed it. It is working now. It would have been nice if all the parts came in a set. Read more

Replaced wash arm mount Read more

Replaced upper and lower spray arms, plus nylon bearings. Read more

This is a 12 year old Kenmore, but my experience applies to many dishwashers. The machine had run for almost a year without being cleaned. I found parts had failed from age and water passages were jammed with hard-water deposits and pieces of food, labels, etc. that had gotten past the filters. I cleaned out what I could and replaced parts that could not be cleaned or were damaged. Dishwasher now works better than it has for years. The work, including ordering parts, took about 4 hours, but... Read more

We bought replacement parts from you and my daughter fixed it. It is working now. It would have been nice if all the parts came in a set. Read more

New fill valve and new heating element. Read more

Put the new parts in I purchased from appliance parts pros, good as new. I used my pocket knife as the only tool. Read more

Although we had a service contract with Sears I elected to take a quick look to see what was wrong. There were 3 problems: 1 - retainer thumb screw had broken and appeared to have been damaged for some time showing scummy buildup along the line where the threads finally separated from the knob, 2 - after removing the lower spray arm, observed that the pump seal was visibly distended and exposed, and 3 - the 3rd level wash arm spinner disk was in the parts bag and the stainless steel sweat-fit... Read more