Skip to Content
  • time delivery images 2 Day Quick Delivery!
  • box-refresh images 365 Day Return Policy!
  • lovely images 15 million satisfied customers
  • boxes images Over 2.1 Million Parts In Stock
  • headphone imagesFree Tech Support!
  • google images Google Trusted Store

Roper Belt

Best Seller
Roper Dryer Drum Belt 92-1/4" 4-Rib
Genuine Whirlpool part
By: Whirlpool
Part Number: 341241

Get your dryer spinning smoothly again - install the Whirlpool 341241 OEM Drum Belt in minutes.

Why this belt?

  • Exact factory spec: 92 ¼-inch length × ¼-inch width, 4 ribs / 3 grooves - built to Whirlpool standards, not a generic copy.
  • Broad compatibility: Fits most Whirlpool-made dryers - Kenmore 110-series, Roper, Estate, Maytag, KitchenAid, Admiral, Crosley, Amana & more.
  • Quiet, durable rubber: Reinforced EPDM resists cracking and stretch for years of reliable tumbling.

Fixes these common dryer problems

Problem How the belt solves it
Drum won’t turn Transfers motor rotation to drum
Loud squealing / thumping Replaces stretched or frayed belt
Burning-rubber smell New belt stops slippage & heat build-up
Damp clothes / long cycles Restores correct drum speed & airflow


DIY install — about 15 minutes

  1. Unplug dryer; remove lint screen housing & front panel.
  2. Release belt tension at idler pulley; lift drum slightly to slide old belt off.
  3. Loop new belt around drum, idler pulley and motor pulley (ribbed side down).
  4. Re-assemble, run test cycle - enjoy quiet, consistent tumbling.

This part fixes the following symptoms
  • Heat stays on after drum has stopped
  • Will not tumble
  • Touchpad does not respond
  • No heat or not enough heat
See more...
Do-It-Yourself Stories from Customers like You Broken dryer belt   Bob B. • St Louis , MO • September 12, 2015

Unpluged dryer first. Then took the lint filter out and removed the two philips screws inside the lint filter lid. Then take a paint scraper just under the top of the dryer two inches from the left front corner and pushed in a little to release the snap connector and did the same on the right side. Then lifted top over. Then take a 5/16 socket or nut driver and remove the two screws on on the left inside panel, then the right side. Lean front out a little and remove the two wires one the back... Read more

More
$14.64
Compare At:
$17.42
You Save:
$2.78

IN STOCK
Ships Today Guaranteed
Add to Cart
Best Seller
Roper Dryer Repair Kit (Most 29 Inch Large Capacity Models)
Genuine Whirlpool part
By: Whirlpool
Part Number: 4392065

The Dryer Repair Kit is an OEM replacement part for Whirlpool 29-inch large capacity dryer models. It is a kit designed to provide various essential components and hardware needed for common dryer repairs or maintenance tasks.

The kit includes:

Please note: Some parts in this kit may not fit your specific model. Use your model number to check for your specific parts.

Causes of needing a dryer repair kit can include worn-out or damaged components due to normal wear and tear, accidental impact or mishandling, or maintenance requirements after a certain period of use.

Symptoms that may indicate the need for a dryer repair kit include:

  • Excessive noise or vibrations during operation
  • Difficulty in opening or closing the dryer door
  • Clothes becoming tangled or wrapped around the drum
  • Leaks or air drafts affecting drying performance

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore dryer models.

This part fixes the following symptoms
  • Will not tumble
  • No heat or not enough heat
See more...
Do-It-Yourself Stories from Customers like You Dryer belt burned up due to wedged sneaker   Benjamin E. • Marietta , GA • September 30, 2014

I was out of the country when the damage occurred but based on my wife's description I knew what had happened. Upon returning to the 1st World, i verified a totally free-spinning drum and ordered a full rebuild kit (rollers, belt & idler). The instruction video was very helpful - especially in listing every single tool needed so i only made one trip to the workshop and brought up exactly what i needed, the first time. Everything went pretty much according to the instructions except that... Read more

More
$34.49
Compare At:
$48.30
You Save:
$13.81

IN STOCK
Ships Today Guaranteed
Add to Cart
Best Seller
Roper Washer Drive Belt
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10006384

The washer drive belt transfers motor power to the washer’s drive system so the basket spins and agitates. Replacing a stretched or broken belt helps stop squealing and slipping so cycles finish at proper spin speed.

What it does

  • Links the drive motor to the washer’s drive/pulley system
  • Restores spin and agitation when the belt is worn, glazed, or broken
  • Can reduce squeal or burning-rubber smells from belt slip
  • Helps prevent intermittent or no-spin conditions

What’s included
One drive belt.

Install notes

  • Unplug power; turn off water
  • Tip the washer back; remove the bottom shield/cover if present
  • Route the belt over the motor and drive pulleys; rotate by hand to seat fully
  • Inspect pulleys/drive parts for wear; run a spin or calibration test after install

This OEM Whirlpool belt is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore washer models.

Do-It-Yourself Stories from Customers like You Whirlpool Cabrio washer made a loud noise during the spin cycles it also was very noisy while washing   Ralph N. • Spring , TX • October 25, 2018

This was my first attempt, ever, to repair a washing machine. After some internet research on the problems, I was able to determine that the shaft seal on the gearcase probably was leaking water into the gearcase with each use. No water was ever found on the floor, but when I turned the washer over to inspect the gearcase, I found a black, oily residue on the outside of it along with the same residue on the pulleys, the belt and the motor. I ordered a new gearcase, shift actuator, splutch... Read more

More
$28.26
Compare At:
$33.63
You Save:
$5.37

IN STOCK
Ships Today Guaranteed
Add to Cart
Best Seller
Roper Dryer Belt (Length 79-1/8 Inch)
Genuine Whirlpool part
By: Whirlpool
Part Number: 3394652

The Dryer Belt (length 79-1/8 inches) is an OEM part for Whirlpool dryers. This belt wraps around the drum, the motor pulley, and the idler pulley to enable the drum to rotate during the drying cycle. It ensures that clothes are tumbled and dried evenly. Also available in repair kit AP3109603

Over time, the dryer belt can become worn or snap due to the constant tension and friction it endures. When the belt fails, the drum will no longer spin, and the dryer will be unable to dry clothes effectively.

Symptoms of a bad dryer belt include:

  • The dryer drum not turning
  • A burning smell from the dryer
  • Unusual noises during operation
  • The dryer running but not tumbling clothes

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

Do-It-Yourself Stories from Customers like You Dryer drum would not turn heat worked fine   Charles K. • Pittsfield , MA • March 03, 2019

I used the web site to figure out the most likely causes for the drum not turning. I watched the web site's videos to see what I would have to do and thought it wasn't too bad; something a rookie could do. Ordered the parts (belt and idler arm) and followed the directions from the videos. Mostly a bunch of screws/bolts to remove with a couple in difficult places. (my dryer isn't full sized) There were some electrical connections to take apart. As i disassembled it, I took pictures of where... Read more

More
$46.95
Compare At:
$55.40
You Save:
$8.45

IN STOCK
Ships Today Guaranteed
Add to Cart
Roper V - Belt Reduction
Genuine Whirlpool part
By: Whirlpool
Part Number: 33331163

 

More

Roper belt replacement parts are essential for maintaining the optimal functionality of your Roper washing machine or dryer. These belts are the unsung heroes responsible for transferring power from the motor to the drum, ensuring your clothes get the thorough cleaning and drying they deserve.

When it comes to Roper parts, quality is key. Using OEM Roper belt parts means you're choosing components designed specifically for your appliance, ensuring a perfect fit and reliable performance. Say goodbye to the stress of breakdowns and interruptions, as these top-notch belts are crafted to meet the high standards set by the original manufacturer.

A fresh Roper belt can often be the solution to maintaining your appliance's efficiency. Investing in genuine Roper belts helps extend the life of your appliance, keeping it running efficiently and effectively.

Finding the right Roper belt replacement parts is easy and straightforward. With these high-quality parts on hand, you can confidently tackle any maintenance tasks, keeping your appliance in peak condition and your laundry day hassle-free.

More
  • boxes images Over 2.1 Million Parts In Stock
  • time delivery images 2 Day Quick Delivery!
  • box-refresh images 365 Day Return Policy!
  • headphone imagesFree Tech Support!
  • google images Google Trusted Store