Roper Wire, Harness, Power Cord

This wire assembly is a factory-style wiring harness that replaces damaged or worn wiring to restore proper electrical connections between appliance components. It helps resolve intermittent power and control issues caused by broken, burnt, or loose wires. What it does:

• Re-establishes reliable electrical connections between controls, motors, switches, or sensors.
• Commonly used when wires are frayed, melted, or have corrosion that causes intermittent operation.
• Can stop symptoms such as no power to a circuit, components not running, or sporadic on/off behavior.
• Maintains routed wire grouping and connector fit to prevent chafing and short circuits.

• Disconnect all power (unplug or turn off breaker) before beginning any repair.
• Take photos of existing routing and connector orientations before removal to ensure correct reinstallation.
• Replace the harness full-length; do not splice or tape damaged wires as a long-term solution.
• Use basic hand tools.

Splicing 25 Ft. Black 12 Ga. 150~c (Wire, Red 14 Ga. 200~c)

This wiring harness assembly routes power and signals between components to restore reliable electrical connections and normal appliance operation. Use it when original wiring is damaged, corroded, or causing intermittent power or control issues. What it does:

• Transfers power and control signals between the appliance control, motors, and sensors
• Replaces frayed, broken, or melted wires that cause intermittent operation or component failures
• Restores reliable connector-to-connector continuity for proper appliance function
• Helps eliminate error codes or non-start conditions caused by open or shorted wiring

• Disconnect power (unplug or shut off breaker) before starting any repair
• Compare the new harness to the old one to ensure connector types and routing before installation
• Route and secure the harness using existing clips/holders; avoid pinching or routing near heat sources
• Test the appliance after installation and restore power only when all panels are properly reinstalled