Briggs Stratton Small Engine Start Switch Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: WP74009254
The fan control switch is the panel-mounted switch that sends power to the appliance's fan motor. Replacing a worn switch restores reliable on/off control and proper airflow so the fan starts and stops when it should.
- Provides user-operated on/off power to the fan/blower motor
- Helps regulate airflow for cooling, venting, or convection depending on model
- Typical symptoms: fan won't run, runs continuously, intermittent operation, or a loose/broken switch shaft
- Mounts behind the control panel and is actuated by the exterior knob/lever
What's included: One fan control switch Install notes:
- Disconnect power at the breaker before servicing
- Remove the control knob/actuator and panel trim to access the switch
- Note wire positions or take a photo; transfer wires one at a time to the new switch
- Secure with the original hardware, restore power, and test operation
Do-It-Yourself Stories from Customers like You
The fan switch on our jenn air cooktop broke Jonathan B. • Bend , OR • March 29, 2015
After looking at several YouTube videos that were only moderately helpful for my particular model, I disconnected the power at the breaker, disconnected the wires below the cooktop to the junction boxed lifted the whole unit out, including the fan assembly. I flipped it upside down and took off the screws holding the unit to the glass top. Although the new fan switch did not look the same as the original switch, the new switch does fit. The new switch did not come with a hex nut. The old hex...
Read more
More
$135.31
- Compare At:
-
$161.02
- You Save:
-
$25.71
Genuine Whirlpool part
By: Whirlpool
Part Number: 12002792
Burner won't spark or ignite? This surface burner ignition switch triggers the spark module when you turn the knob. 45-minute DIY repair for ranges.
Do-It-Yourself Stories from Customers like You
Igniter switch shorted out Jeff J. • Hoffman Estates , IL • October 11, 2016
Replaced switch assembly
Read more
More
$102.32
- Compare At:
-
$121.76
- You Save:
-
$19.44
Genuine Whirlpool part
By: Whirlpool
Part Number: 8201769
Refrigerator not cooling or compressor running hot? This start device kit includes relay and overload to restore proper compressor function. DIY install.
Do-It-Yourself Stories from Customers like You
No cooling and no hum from compressor when plugged in Collin H. • Quincy , WA • October 23, 2014
I suspected the start-relay and tested it due to the lint plugged condenser coils. The start-relay rattled when shook, a telling sign it is no good due to over heating. I tested the compressor terminals and compared them the results with the Tech Data Sheet found with the unit, to find my compressor was still good. I checked the start capacitor with a capacitor tester, comparing the results with the rating printed on the side of the capacitor and found it to be good. I cleaned the condenser...
Read more
More
$88.95
- Compare At:
-
$104.96
- You Save:
-
$16.01
Genuine Ge part
By: Ge
Part Number: WH12X10510
Washer won't respond to cycle selections? This selector switch mounts behind the control knob to restore reliable setting changes. Easy DIY fix.
More
$27.79
- Compare At:
-
$33.35
- You Save:
-
$5.56
Genuine Broan part
By: Broan
Part Number: S97011238
Fan or light not responding? Intermittent operation or loose controls? This range hood switch restores reliable on/off control. Simple DIY fix.
Do-It-Yourself Stories from Customers like You
Kitchen downdraft unit not functioning Melvin S. • Spring Valley , CA • June 24, 2014
Called a close friend, does all or most repairs around home for years. Dismantled downdraft unit and discovered a bad switch. Was able to ascertain part number and manufacturer. One phone call managed to locate part in stock. Ordered and part arrived in express time!. Friend came yesterday, installed part and put assembly back together. Unit works like new. Great thanks for all the help from Appliance Parts Pros.
Read more
More
$50.26
- Compare At:
-
$60.31
- You Save:
-
$10.05
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304482236
If your hood won't turn on or respond to controls, this switch may have failed. Requires removing the grease filter and lower pan to access and replace.
More
$125.95
- Compare At:
-
$151.14
- You Save:
-
$25.19
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304524331
Interior light stays on or won't turn on? This upright freezer door switch controls lighting when the door opens and closes. Simple fix for most DIYers.
More
$57.39
- Compare At:
-
$68.29
- You Save:
-
$10.90
Genuine Ge part
By: Ge
Part Number: WE4M407
Fix a dryer that overheats or won't heat properly with a new temperature switch. Controls heat settings across multiple cycles. DIY-friendly repair.
More
$112.45
- Compare At:
-
$132.69
- You Save:
-
$20.24
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10295048
If your electric range burner won't heat properly or won't turn off, this infinite switch controls power to the surface element. Moderate DIY repair.
More
$84.95
- Compare At:
-
$100.24
- You Save:
-
$15.29
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304491944
This kit includes the electrical components needed to start your refrigerator's compressor motor, including both the start relay and overload protector. These parts work together to provide the initial electrical boost needed to start the compressor and protect it from electrical overload. Replace this kit if your refrigerator isn't cooling, makes clicking noises, or if the compressor won't start.
Do-It-Yourself Stories from Customers like You
Smelled bad all of a sudden Austin K. • Chowchilla , CA • May 10, 2014
The smell was bad. Burnt wires but smelled like it could be a critter. Saw that the starter relay smoked after a cycle. Ordered the part.(sunday). Part recieved on Monday. Installed in less than ten minutes. Wife was happy. Also the website had a video of how to replace the part. Very satisfied??
Read more
More
$114.95
- Compare At:
-
$136.79
- You Save:
-
$21.84
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3356467
Washer won't fill properly or overfills? This water level pressure switch senses fill levels and signals when to stop. Easy DIY fix for cycle timing issues.
Do-It-Yourself Stories from Customers like You
Wash machine once in a while would stop running Daniel B. • Leesburg , FL • May 13, 2016
I found that turning the water level switch back and forth would activate the machine So I replaced the water level switch and the plastic hose that connected to it.
I purchased a clamp in the purchase, but it was the wrong size! There wasn't a clamp used in the original set up, so I installed the switch and hose without it! It was the video instructions and having the correct parts that made that made this a easy repair!
Thank You
Read more
More
$108.40
- Compare At:
-
$129.00
- You Save:
-
$20.60
Genuine Ge part
By: Ge
Part Number: WR07X10097
Fix clicking sounds and warm temps with this start relay and overload protector. Controls compressor start-up and prevents overheating. 15-minute DIY fix.
Do-It-Yourself Stories from Customers like You
Would not run led dimmed condenser fan would not run Pete M. • Santa Fe , NM • May 16, 2015
We replaced the main circuit board and the LED started to work and the condenser fan worked, but all we had were relay clicking sounds, but no cooling. The compressor had become so hot trying to work when the main circuit board was amiss, that it had popped the over temperature sensor on its side. As some one point out, if you remove the PTC+OLP assembly with the capacitor on it, and shake it, you will hear a rattle inside---and that is bad. We ordered a second round of parts from...
Read more
More
$113.95
- Compare At:
-
$135.60
- You Save:
-
$21.65
Genuine Lg part
By: Lg
Part Number: 0CZZJB2014G
This capacitor stores and releases electrical energy to support the appliance's circuit during startup and operation. Replacing a weakened capacitor can restore reliable performance and reduce humming, hard starting, or stalling in the affected component.
- Provides a power boost at startup and helps stabilize voltage during operation
- Helps the connected component start promptly and operate smoothly under load
- Common failure signs include humming, slow or no start, or intermittent operation
- Contribute to overheating or a tripped breaker/fuse when the component tries to start
What's included: One capacitor. Install notes:
- Disconnect power at the breaker or unplug the appliance. Before handling, safely discharge the old capacitor using a proper resistor-rated tool.
- Photograph or note wire positions; move each lead to the same-labeled terminal on the new capacitor and ensure snug connections.
- Mount the capacitor securely in its bracket; keep terminals covered and clear of metal surfaces.
Do-It-Yourself Stories from Customers like You
Loud clicking from the back of my refrigerator Randy W. • Granbury , TX • March 04, 2015
Research question lead to others that had the same issue. Consensus lead to a common repair. Compressor overload switch going bad. After ordering the correct parts, I changed out both the switch and the motor start capacitor just in case. After cleaning the equipment, I then put everything back together. Results were, clicking gone, seems to be quieter operation because of cleaning, more efficient cooling and nerves calmed.
Read more
More
$43.79
- Compare At:
-
$52.11
- You Save:
-
$8.32
Genuine Whirlpool part
By: Whirlpool
Part Number: 4387535
Fridge not cooling but lights work? This compressor overload stops overheating and prevents startup damage. DIY-friendly repair in about 1 hour.
This part fixes the following symptoms
-
Won't start
-
Fridge too warm
See more...
Do-It-Yourself Stories from Customers like You
Overload switch stopped working turning off the refrigerator compressor J Michael L. • Waxahachie , TX • August 06, 2016
Replaced overload switch and start relay with convenient repair set.Video available on website that gave step by step instructions. Followed the video steps for removal and installation.... plugged in the refrigerator compressor started up everything cool in minutes
Read more
More
$87.27
- Compare At:
-
$104.72
- You Save:
-
$17.45
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304491583
This controller kit is the appliance's main electronic control. It reads inputs from the user interface and sensors to power and coordinate key components. Replacing a failed controller restores responsive controls and consistent, reliable operation.
- Interprets commands from the keypad and sensors to manage operation
- Controls relays powering motors, fans, compressor, or valves as designed
- Coordinates modes and cycle timing for proper performance
- Common symptoms: dead or blank display, unresponsive buttons, won't start, intermittent shutdowns, or error codes
What's included: 1 controller kit Installation notes:
- Disconnect power at the breaker or unplug the appliance before servicing
- Handle the board with ESD precautions; avoid touching connectors and components
- Photograph/label wire connections and transfer them one at a time to the new board
- After installation, verify any model-specific settings per the service documentation before testing
Do-It-Yourself Stories from Customers like You
Feezor would not run Russell B. • Groton , CT • February 15, 2016
Replaced controller and starter relay
Read more
More
$88.95
- Compare At:
-
$105.85
- You Save:
-
$16.90
Genuine Samsung part
By: Samsung
Part Number: DA34-10120E
Refrigerator light not turning on when door opens? The door switch detects door position to control interior lighting. Simple DIY replacement.
This part fixes the following symptoms
-
Light not working
-
Not dispensing water
-
Ice maker not making ice
See more...
More
$48.95
- Compare At:
-
$58.25
- You Save:
-
$9.30