Thermador Parts

Fix an oven door that won't close or latch properly with this push-release door latch assembly. Direct fit for electric wall ovens and ranges.

Oven not heating or overheating? A faulty thermostat disrupts temperature regulation. This replacement restores accurate oven temperature control.

The Bracket, Motor Mounting is an OEM part for Bosch range hoods. It is responsible for securely mounting the internal motor and fan assembly within the range hood structure. The motor mounting bracket provides a sturdy foundation that isolates vibrations and minimizes noise transfer during operation.

Causes of a bad bracket can include cracks, breaks, or detachment from normal wear and tear over time or failure from repeated exposure to motor vibrations.

Symptoms of a bad bracket include:

• Loosening or detachment of the internal motor/fan assembly
• Increase in noise levels and vibration transfer to surrounding cabinets
• Instability or shifting of the motor during range hood operation
• Possible interference or contact between moving components

Replacing with this OEM Bosch bracket restores the proper mounting and isolation of drivetrain components, ensuring smooth, reliable performance. This part is also compatible with Thermador, Gaggenau, and some Kenmore branded range hood models.
 

This door latch assembly secures the door closed and signals the control that it's safely shut, allowing cycles to start and run. Replacing a worn latch restores a reliable safety interlock and consistent operation.

• Secures the door and engages the safety interlock so the appliance can operate
• Sends a "door closed" signal to the control
• Common symptoms: door won't latch or stay closed; unit won't start or pauses as if the door is open; intermittent operation when the door is bumped; visible wear or damage to the latch
• Helps prevent nuisance "door open" indications

• Disconnect power before servicing
• Access the latch from the door area; remove inner panel or trim as required by your model
• Note wire positions, transfer connectors, and mount the new latch in the same orientation
• Test door closure before reassembly