Whirlpool Cooktop Parts

You have to take the knob off the broken part, then buy the new switch element and fix it. To do this you turn the power off, take out 6 fasteners to release the front panel of the stove and replace the switch element. Then put it all back together. Very simple. But if the knob was designed better it would not have broken in the first place. It looks nice, but this is the third time I have had to fix one. Read more

I replaced the old burner with the new burner assembly which included the ignighter. The screw that held the old ignighter was frozen into the old burner such that just the ignighter could not be replaced. Be care full removing the screws to the burner as they also may be frozen and tend to snap off instead of unscrewing. You will need to drill an tap new holes. Read more

Replaced control module. Read more

• Oven not heating evenly

Ordered new screws and door gasket. Replaced the old door gasket now the oven warms up faster and bakes the stuff easier. Replaced the missing door trim screws. Now the door close without making noises. Read more

Replaced the switch in the back panel, SUPER easy!! Read more

I ordered four replacement grates at a savings of $100 off the price quoted to me by a local appliance repair company. Read more

Replaced fuse. It took much longer to get the oven out of the wall to access the fuse and replace the front panel than to do the repair. This fuse failed at the end of the cleaning cycle for the bottom oven and left the door locked because the open fuse removed the 120v power from the control board. The locked door made it impossible to remove one of the screws holding the wall oven in place. However, after I ground off the head of the screw behind the edge of the locked door I was able to... Read more

• Door won't close

Replaced the hinge and receiver. Read more

We replaced both front orifice holders. Very easy to bend and break. If it has a deep bend in it, It will slow down the gas flow to the burner. if you have a low gas flow your burner will burn low So check your small silver gas lines and if you smell gas check your lines Read more

• Little to no heat when broiling
• Gas igniter glows, but will not light

Called a repairman and he told us we needed to change a bunch of parts and would cost over $400! Decided to do some research online and found suggestions to replace the spark igniter. Decided to give it a try. Took about 10min to replace and oven is now working perfectly, for a total of $30! Read more

Bought a new knob. Read more

Replace the burner part that was broken. Read more

Ordered part and installed it. Broiler works as advertised. Read more

My husband had been searching for replacement parts of over a year. I found your website and asked one of your employees... received a response the following day and ordered the parts! Super simple, and now I have new foot pads that fit my stove burner grates. Thanks so much! Read more

REPLACED ORIFICES TO BURNERS VERY EASY JOB. Read more

• Won't start

Replaced module: Although the new module was slightly different due to a third or ground terminal that was not on the original I managed to figured out that I did not need to worry about the ground since the existing wiring had already allowed for the connection. Easy repair. I ordered the part one day and it was delivered the next and that was using the least expensive delivery service. You guys are great Read more