Whirlpool Range / Cooktop / Oven Parts

Bought replacement burner receptacles. Cut off the old ones, used wire nuts to connect replacements. Read more

By myself with my own two hands, a towel, and a screwdriver! I was able to find a video tutorial for how to disassemble my oven. And bonus, I got to do a bang up job on the glass while at, inside and out! As a woman, I was pleasantly surprised at how easy this was. Read more

I watched an 8-minute video on YouTube. Identified and ordered the part from AppliancePartsPros that a $12 shipping fee was received in 2 days. Took 10 minutes or less to install. Years ago without next-day parts and YouTube, this $60 repair would have cost me $200+. Read more

Easy fix you guys were spot on. Read more

• Little to no heat when baking

Wire on one side became disconnected. Had to pull the oven out and reconnect it. Read more

You found the parts we need and we installed them. The sales person was excellent. Read more

Replaced the inside door glass. Read more

First, I just unscrewed all nuts that are holding the frame and all surface elements. Once all parts, surface elements, control switches, are loose from the original glass, I just moved all parts to the new glass. Due to the weight of the glass, all actions have to be done carefully as I broken one corner of the glass couple of years ago when I replaced one of the control switch. Read more

Replaced seal. Ordered seal on Monday, had it Tuesday. It was the exact seal for the oven. It took longer to clean up the oven around seal groove than to remove and replace the seal. Read more

I replaced the hinges, which involved removing the door by opening it all the way, inserting a small allen wrench into the locking pin hole on each of the two hinges, partially closing the door and pulling it toward me. I then laid the door stainless steel face up on a table, removed the 8 screws from the edge and pulled the bottom of the face up and toward me. The hinges lie loose in their compartments, so it's easy to pluck them out and drop the new ones in. To retrieve my allen wrenches... Read more

• Door won't open after self cleaning cycle

Based on information found at AppliancePartsPros, I determined that the it was most likely the thermostat (thermal fuse). I removed the rear panel and tested the fuse for continuity and it was bad. I used a jumper wire to bypass the fuse and plugged the range back in. The panel turned on and the oven unlocked. I then removed the thermostat and looked up the replacement part and ordered. Read more

I replaced the Oven Igniter. After ensuring that it was the igniter, by turning on the stove and taking out the oven bottom. Watch if it turns red. If not, then either the wiring is faulty, or the igniter went bad. The bulb was due to a loose and broken light bulb, can't use any normal bulb, these ones are specially made to withstand the heat. And the oven bottom was warped due repeatedly heating up and cooling down over the years. It took a fair bit of time to get the new one in, since it was... Read more

Followed the video instructions from appliance parts pro.com ! Read more