Whirlpool Range Parts

• Door won't open or close

The replacement hinge unit arrived in just two days. The JennAire (Maytag) oven door is fairly typical in that it easily lifts off of the hinge bars. Once the door is off then removing two screws is all that's required to remove the hinge unit from the oven. The new hinge slides up into place and while you hold it up inside of its location putting the old screws back in is very easy. After sliding the door back down onto the hinge bars the oven is as good as new Read more

I was able to clean the Oven Temp Sensor with 99% alcohol. Then replaced All switches (after breaker was isolated). Put it all back the way I found it. Turned on breaker. Tested all functions and had no reports of Fan Code re-appearing since. Read more

I ordered a replacement glass from Appliance Part Pros on Friday evening and it was delivered on Monday morning. It was packed well and I appreciated the quick delivery. I watched the Appliance Part Pros video and it was not helpful because it was for a different door but it did have some useful advice. I checked for a few other hints on the internet and then went to work. The door on my oven had to be removed by opening it to the first stop, about four inches, after removing two locking... Read more

My son help me to change, and also he changed the belt as it was old. It took him about 45 minutes overall Read more

Found the parts on AppliancePartsPros.com. Very easy, found the right parts. Read more

Our oven went out because of a power failure while the oven was on. I purchased an ignitor from a local repair place but it still would not work. We were told it could be the control panel. We ordered another ignitor just in case and also the control panel. We put both parts in, turned on the gas and electric and the oven came right on, I am a very happy wife. This company is great, they are not only fast on shipping, there customer service is very concerned about your identify when you order... Read more

I have a 10 year old Kitchenaid double oven with warming drawer below and electrical connection is located in cabinet below. I order a service manual from http://www.allrepairmanuals.com. If you have the service manual follow it, it walks a technician thru each step. If you don't have a manual here are a few highlights. Disclaimer the following is for my oven model KEBS208DBL8, your oven service steps may vary. IMPORTANT! First step turn-off the power to the oven (mine was a 40 amp breaker)... Read more

Attached new handle with screws. Read more

• Gas igniter glows, but will not light

Everything works great, but my Jenn-Air stove is more than 15 years old and really needed a face lift. To replace it will cost about $3000.00 to replace, to replace missing and old parts around $500.00. Thankfully Appliance Parts Pros had all the parts I needed to make my stove look as good as it works. Read more

• Won't start

I removed the burners and replaced the igniters. The burners must be removed because the igniters go underneath them. This job turned out to be very difficult because my stove is 16 years old and the screws holding down the igniters were completely rusted and bound to the stove top, so I had to drill out all of the screws. Also, the burners were bound to the gas flues by mineral deposits and separating them was very difficult. Once I got the stove top up, I threaded the igniter wires to the... Read more

Replace with a new knob. Read more

Replaced with a new control knob. Read more