Whirlpool Refrigerator Motor

The repair went well. Never made this type of repair before. Took me around 90 minutes to complete. The worst part was winging it on how to disassemble the bottom drawers. On my Kenmore Elite, it has three freezer compartment sliding trays. The other difficult part for me was removing the clipped in part on the back of the freezer panel. Without knowing what to do it was a little frustrating. after getting to the evaporator unit, removing built-up ice and replacing the unit was fairly easy. The... Read more

I received my new part in about 3-4 days. Part was exact match for my existing motor. After watching the installation video on this website I was able to garner the rudimentary directions to replace the motor. The video did not match the exact fridge I had. My fridge did not have the access panel on the interior of the freezer. I had to remove the two screws at the water ice dispenser tray on the outside and slide that unit off the front. Before removing the motor, open the freezer and remove... Read more

After checking the suggested fixes and parts on Appliance Parts Pros, I ordered the defrost thermostat and evap motor for my refrigerator, a Kitchen Aid KSSC42QTS00. Installation was very easy, simply emptying the freezer and removing the access panel in the back bottom half. Upon getting everything open, I found out that the existing evap motor was working fine, so I didn't install that part. I did install the defrost thermometer, which was a 5-minute process. I also cleared out the vent... Read more

Very easy to replace. Take off cover to auger compartment. Unplug power connector from auger motor. Remove four screws holding auger motor to refrig. Put new auger motor in place, insert screws, insert power connector, replace cover. Use ice maker! Read more

Checked and found the evaporator frozen causing the fan to stop working. Took the interior panels off and applied a blow dryer to the ice, once the ice melted I cut the tabs on the grommet holding the fan since everything is thin plastic and replaced the grommet and fan. Placed everything back and found no further issues. Tools I used were a small flat head screwdriver to pry the panels off and a 1/4 socket to remove the center drawer (4), water filter cover (2), and the ice maker (2). Not too... Read more

Originally thought it was the evap fan motor, possibly the control board. Turns out it was the latter but only way to know for sure was to replace fan first. Shipping was fast and the parts were good. Read more

After tossing a couple for refrigerators to clean the storage area - we had one good one left taken from an apartment where the resident bought a newer-bigger one. Another resident's went bad - froze in the freezer - but 65 F in the lower refrigerator unit. Not my job but I decided to check it - diassembled the freezer plastic - fan didn't run - took it out and direct powered it - dead! I went on line and reviewed numerous Goolgle hits - yours was easiest to work in - put in the OEM P/N - you... Read more

Added a new shaft as the old shaft had worn down...........works perfect now. Thank you Easy fix ....no more than 10 mins. Read more

Replaced fan motor Read more

• Noisy

I watched videos to diagnose the noise coming from my refrigerator, then watched videos on how to replace the part, then I ordered the replacement part which came very promptly. The part works perfectly. I am a 73-year old woman, and found this was an easy fix, even on a bottom freezer model refrigerator. The AppliancePartsPro price for this part is a good buy, and I will buy again when I need a part. I have ordered replacement parts from AppliancePartsPro for my cooking range previously and... Read more

The evaporator fan had stopped working and caused the entire area around it to ice up. No air flow was getting from the freezer to the fridge. I replaced the damper control (it was rusted, not sure if it was workign or not) and the evaporator fan. It was a very quick repair once I diagnosed the problem. The most time consuming part was taking all the compartments apart to get to the affected area. Read more

Watched video on replacing motor, ordered part, replaced it in less than 15 minutes. Works great! Read more

The fan blade had vibrated down the shaft of motor and was hitting the fan supports. I replaced motor and new fan blade. The motor was still operating but since I had everything opened up I changed out the motor anyway. Freezer working fine now. The only unforeseen problem is there was a black wire that had to be transferred to the three prong wiring harness. Read more

Replaced evaporator fan in back wall of freezer. Read more

Replaced the auger motor. Read more