Whirlpool Refrigerator Parts

I went to appliancepartspros.com and described the symptoms which led to replacing the capacitor. The part arrived the next day!!! Unfortunately the clicking and warmness remained. I went to the online chat and Mandie recommended the relay which was next in the chain before the dreaded compressor. Once again the part arrived the next morning! I snapped it in and I was back in business, 90 dollars total in the two parts. No service call with the standard "it's the compressor" diagnosis. ... Read more

I pulled the old gasket off the door then I used rubbing alcohol to clean the mold along the back of the door and in the insert for the gasket seals . The new gasket fit extremely well and was very easy to put in. I waited 24 hours for the gasket to come back to its normal shape. After putting the gasket in I waited another 24 hours to make sure that I was getting no Icing inside the freezer area. There was no icing so the job is completed. Read more

I ordered a new drawer bin. Read more

• Ice maker not making ice
• Leaking

Replaced it Read more

Not really a fix, just a replacement. My wife hated the perfectly good duct tape I used to hold the two drawers together so I finally decided to replace them. HAPPY WIFE, HAPPY LIFE!!!! Read more

Replaced not only the ice chute door flap which was squashed from years of use but the mechanism and motor that operates the flap. The old mechanism seemed to work but it seemed a little sloppy or loose. I knew the flap was bad but for the extra few dollars I thought since I had to take the cover off anyway, why not replace the whole thing. I’m glad I did. The new motor and mechanism has been reengineered and is much tighter in the way it operates. The ice chute door seats securely and the ice... Read more

"It was a snap", following the YouTube video by Appliance Parts Pros, it just snapped into place. Read more

Replaced the motor and fan blades exelente fitting work great Read more

• Not dispensing water

Kenmore model 106.74252402 fridge with icemaker. Believe it or not, this was fixed with only a 1/4" nutdriver. The parts fit exactly and took 10 minutes each to replace. The most surprising was the inlet valve. I didn't need to cut any tubing since the old valve had push-connectors like the replacement. It was identical. Simply pushed the fitting to remove old tubing and pushed into new part. Pull off plugs and push onto new part. 2 screws hold valve to fridge frame. Screw cardboard cover... Read more

Replaced heater and defrost timer. All parts fixed perfectly with no modifications. I recevied my parts in 2 days!! Great service, great prices. I will return to your site when i need parts and advice again. Thank you!! Read more

Removed the old tube. You will need this part - note that it might look different from what you have because they redesigned the part to not have a sharp curve at the bottom part where it plugs into the valve. You will also need a 5/8" stainless steel hose clamp (that will go down to 1/4") to clamp the top part of the hose that feeds into the icemaker (this replaces the factory clamp that is effectively throw-away). Read more

Water dispenser came down to a trickle and made a lot of noise, I changed the filter but it didnt help and thus the water tank/head assembly needed to be replaced. Replacing the water Tank/head assembly was an easy task, the hardest part is removing the covers and taking care of not breaking the insulation of the water inlet hose. For the not-so-experts like me it is also good to rememebr to have a bucket to collect all the water that comes out after the connection to the solenoid valves is... Read more

Removed the plastic shield, then unscrewed old bulb. Screwed in new bulb. New bulb has a slightly different screw base. Looked in several stores that carry appliance bulbs and could not find any bulbs that matched the unusual screw base. Replacing the snap-in plastic shield was difficult. It might have been easier if I had taken the freezer drawer out. Read more