Whirlpool Wall Oven Parts

The Grease Filter is an OEM part for Whirlpool range hoods. This part traps grease particles from the air as it circulates through the range hood, preventing grease buildup on the blower and other internal components, thus maintaining the efficiency and longevity of the range hood.

Causes of a bad grease filter can include clogging from excessive grease accumulation, physical damage from improper cleaning or handling, and general wear and tear over time.

Symptoms of a bad grease filter include:

• Reduced air flow from the range hood
• Visible grease buildup on or around the filter
• Unusual odors persisting in the kitchen
• Filter appearing worn or damaged

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

Restore reliable operation with this electronic control board, the appliance's central "brain." It manages inputs and outputs so programmed functions run correctly, helping resolve unresponsive controls and erratic or failed cycles.

• Directs and times operations based on user commands and sensor feedback
• Distributes power to components such as motors, valves, heaters, lights, or fans as required
• Monitors switches/sensors to maintain proper performance
• Symptoms can include no power, won't start, unresponsive buttons, random resets, incomplete cycles, or error codes

• Disconnect power before servicing; verify no voltage is present
• Use ESD precautions and handle the board by its edges
• Photograph wiring/connectors to ensure correct reassembly
• Mount in the original position and refer to the unit's tech sheet for any required setup or diagnostics after installation

The Knob is an OEM part for Whirlpool ranges. This knob allows you to control the temperature and settings of your range burners, ensuring precise cooking adjustments.

Causes of a bad range knob can include frequent use leading to wear and tear, accidental damage from dropping or impact, or exposure to high heat causing it to melt or crack.

Symptoms of a bad range knob include:

• Difficulty turning the knob or adjusting the burner settings
• The knob feeling loose or not fitting securely on the control shaft
• Visible cracks or breaks on the knob
• Inconsistent or unresponsive burner operation

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

The Infinite Switch is an OEM part for Whirlpool ranges. This part allows for precise temperature control and seamless operation of the left front heating elements.

Causes of a bad part can stem from electrical issues, such as power surges or short circuits, physical damage from impact or mishandling, or general wear and tear over time, leading to deterioration of the switch's internal components or connections.

Symptoms of a bad Infinite Switch in a range include:

• Difficulty in adjusting or maintaining desired temperature settings for the burners
• Erratic heating behavior, with burners cycling on and off unexpectedly
• Complete failure of one or more burners to turn on or remain on at the selected setting

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

The Surface Element is an OEM replacement part for Whirlpool ranges. It is responsible for generating heat on the cooktop, allowing for efficient and even cooking. This component is designed to provide adjustable heat levels to accommodate various cooking needs, from simmering to boiling.

Symptoms of a bad Surface Element include:

• Inconsistent heating or failure to heat up
• Visible damage or wear, such as burns or warping
• Electrical issues, like sparking or short-circuiting

Causes for a malfunctioning Surface Element can be attributed to electrical failures, prolonged use at high temperatures, or physical damage due to spills and overflows.

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This Whirlpool Range Control Board is an OEM part for a variety of Whirlpool range models. It serves as the electronic brain of the range, managing functions such as temperature regulation, timer settings, and various cooking modes. 

The control board in a range can be susceptible to issues like electrical faults, short circuits, or damage from power surges. A malfunctioning control board can lead to erratic temperature controls, display errors, or non-responsive buttons, hindering your ability to cook effectively.

Symptoms of a defective range control board include:

• The oven fails to heat up or maintain the set temperature.
• Digital displays show error codes or become unresponsive.
• The oven controls do not respond or work intermittently.
• Unusual behavior in cooking modes, such as the broiler activating unexpectedly.
• The oven timer functions incorrectly or not at all.

This genuine Whirlpool OEM replacement part is compatible with Maytag, Jenn-Air, and Kenmore models.
 

The Leveling Leg is an OEM replacement part for Whirlpool ranges. These adjustable legs help balance and stabilize the range.

Causes of a bad leveling leg commonly involve wear over time, thread or weld failures from supporting heavy loads, as well as damage due to impact or drops during installation.

Symptoms of a faulty leveling leg include:

• Instability such as rocking motions felt while cooking
• Uneven heating
• Doors that do not close properly

This is a genuine Whirlpool OEM replacement this part is also compatible with Maytag, Jenn-Air and some Kenmore models.

The Burner Cap (Black) is an OEM part for Whirlpool gas ranges. This cap sits on top of the burner head for the left rear and center, evenly distributing the flame for efficient cooking and protecting the burner head from spills and debris. It is designed to withstand high temperatures and ensure consistent heating performance. The caps fit the left and right front burners.

Common causes of a bad burner cap include chipping or cracking from thermal stress, rust or corrosion from spills, and wear from frequent cleaning.

Symptoms of a bad burner cap include:

• Uneven or weak flame distribution
• Difficulty in lighting the burner
• Visible cracks, chips, or discoloration on the cap
• The burner not functioning efficiently

This OEM part is also compatible with some Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This replacement light bulb restores interior illumination inside your appliance. Swap it in for a burned-out bulb so you can clearly see contents and monitor operation when the door opens or the light button is pressed.

• Provides interior light inside the appliance cavity
• Direct replacement for a failed or broken bulb
• Common symptoms: no light when the door opens, flickering/intermittent light, visibly darkened or broken bulb

• Disconnect power to the appliance before servicing
• Allow the old bulb and nearby surfaces to cool completely
• Remove any lens or cover to access the socket; install the new bulb in the same orientation as the original
• Handle with clean, dry hands or gloves; do not overtighten. Restore power and test

The Charcoal Filter is an OEM part for Whirlpool microwaves. This filter is designed to remove cooking odors and smoke from the air circulated through the microwave's venting system. It is especially important in over-the-range microwaves that recirculate air rather than venting it outside. The filter measures about 12 inches wide by 6 inches deep. This is a 2 Pack.

Causes of a bad charcoal filter can include saturation from grease and odors over time, blockage from accumulated debris, or deterioration of the filter material. Regular replacement is necessary to maintain effective air filtration and proper microwave performance.

Symptoms of a bad Charcoal Filter include:

• Persistent cooking odors lingering in the kitchen
• Reduced ventilation efficiency
• Smoke not being properly filtered during cooking
• Noticeable decrease in the microwave's air circulation

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This thermal fuse is a one-time safety cutoff for select ovens. It opens if excessive heat is detected, interrupting power to the control circuit to help protect components. Replacing a blown fuse may restore control/display power.

• Opens permanently at approximately 105°C (221°F) to cut power during overheat conditions
• Helps protect the electronic control and wiring from heat damage
• Addresses: blank display or unresponsive controls, oven not heating, unit shutting off during self-clean or high-heat use

• Disconnect power at the breaker before servicing
• Location varies by model; typically mounted on the oven cabinet near the control area or cooling system
• Replace like-for-like; do not bypass. Transfer existing connectors and secure in the original position
• Check cooling fan operation, airflow/vents, and wiring to correct the cause of overheating

• Cut-off temperature: 105°C (221°F)
• Non-resettable (one-time) fuse

This 30-inch towel-bar style door handle spans the appliance door and provides a solid, comfortable grip. Replace a bent, cracked, or missing handle to restore safe door operation and a clean, like-new front appearance. What it does:

• Serves as the long, bar-style grip used to open and close the door
• Direct replacement for a handle that is loose, cracked, dented, or missing
• Helps restore safe, comfortable door operation and front-panel appearance

• 1 door handle (towel bar, 30-inch)

• Disconnect power and allow the appliance to cool completely before starting
• Protect glass and trim; support the door during service
• On most models, remove the inner door panel to access the handle fasteners
• Reuse existing mounting hardware and any end caps/spacers if equipped; tighten evenly and test door operation

The Door Latch is an OEM replacement part for Whirlpool ranges. It is the mechanism that securely holds the range door shut during cooking operations.

Causes for a bad door latch can include wear and tear of moving parts over time exposing them to high heat, improper cleaning allowing residue to build up and corrode components, or physical damage like bending from excessive force on the door.

Symptoms of a door latch issue include:

• Inability to fully close the range door
• Sagging or loose door that does not feel secure during baking and broiling
• Door that will not safely stay shut on its own

This is a genuine Whirlpool OEM replacement this part is also compatible with Maytag, Jenn-Air and some Kenmore models.

Note: Includes ignitor

The Whirlpool orifice holder is an OEM replacement part responsible for regulating the flow of gas to the surface burners of the cooktop. This part ensures the safe delivery of gas to the burner, allowing for controlled ignition and heat generation. The orifice holder is located beneath the burner assembly, and it connects to the gas supply line. It contains the orifice, which is a small opening that determines the gas flow rate to the burner.

Causes of a bad holder-orifice can include wear and tear over time, exposure to high temperatures, or accidental damage during maintenance or cleaning. When the holder-orifice becomes compromised, it can lead to issues with gas flow and burner efficiency, impacting the overall performance of the oven.

Symptoms of a bad Holder-Orifice include:

• Uneven heating or burner performance
• Weak or inconsistent flame
• Gas smell near the burner area
• The burner not igniting properly

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

The Spark Module is an OEM replacement part for Whirlpool ranges. This module generates and distributes the electrical current needed to ignite the range burners. Dependable sparking is essential for safe and efficient burner ignition.

Causes of a bad spark module can include cracked circuit boards, worn-out electrodes, or malfunctions in the module's timing mechanism.

Symptoms of a bad spark module include:

• Burners failing to light or taking excessive time to ignite
• Constant tripping of the oven or range thermal fuse
• Visible flames or smells coming from under the burners
• Inability to start or maintain oven/range heating functions

This is a genuine Whirlpool OEM replacement this part is also compatible with Maytag, Jenn-Air, and some Kenmore models.