Admiral Hose Or Tube

Kit contains two 10 feet inlet hoses.

This waterline assembly supplies water from the household line to the refrigerator's ice maker and/or water dispenser, restoring reliable water flow and preventing leaks from damaged tubing. Ideal when the fridge isn't filling or water is leaking. What it does

• Carries water from the home supply to the refrigerator ice maker/water dispenser
• Replaces cracked, pinched, or leaking tubing that causes visible leaks or puddles
• Restores normal fill to the ice maker and consistent water flow to the dispenser
• Helps eliminate slow or intermittent fill issues caused by restricted or damaged lines

• One waterline assembly with attached fittings as shown

• Shut off the home water supply and unplug the refrigerator before starting
• Tighten fittings to manufacturer torque—do not overtighten plastic fittings
• Inspect existing connections and replace any damaged shutoff valves or connectors
• After installation, turn water back on and check all connections for leaks; flush line per manufacturer instructions

This drain hose routes wastewater from the appliance to the household drain, helping remove used water after a cycle. It replaces a damaged, kinked or leaking hose to restore proper draining and prevent puddling. What it does:

• Carries discharge water away from the appliance during drain cycles
• Restores proper draining when the original hose is cracked, split or leaking
• Helps prevent backups and standing water inside the appliance
• Works with the appliance's pump and drain system to maintain normal operation

• One replacement drain hose

• Disconnect power and water before starting any work
• Verify hose routing and secure clamps to prevent kinks and leaks
• Inspect and replace any worn clamps or fittings as needed
• After installation, run a short cycle and check for leaks and proper drainage

This grommet seals the appliance's fill tube to keep the water path watertight and properly routed. It helps prevent leaks where the fill tube passes through the cabinet or dispenser area. What it does:

• Seals the fill tube connection to stop drips and slow leaks
• Keeps water flowing along the intended path to the dispenser or valve
• Cushions the tube where it passes through panels to reduce wear
• Helps prevent water damage and maintain normal fill operation

• Turn off power and shut off the water supply before servicing
• Access the fill tube area per your model's service instructions; grommet typically presses into an opening and the tube pushes through
• Inspect the tube and surrounding area for damage; replace if cracked or excessively worn
• After installation, restore water and power, then check for leaks during a short fill cycle