Admiral Refrigerator Parts

Watched the video at Appliance Parts Pros. Followed the video. I was fixing the refrigerator door (a little easier then the freezer door). The repair was very simple and took less then 15 minutes. Read more

The website made it very simple to find the replacement shelves I needed. I measured them before my order and checked to see if they were the right size. When they arrived I simply took them out of the package and lined up the shelf tabs in the slots of the refrigerator, and pushed down to install. Easy! Read more

Ordered new enclosure. Place ice maker into 'off' position. Remove ice tray assembly by pulling forward. Unscrew left hand side screw under old enclosure. Pulled broken part forward and up slightly. Unhooked wire harness from back of freezer. You can reach from underneath pulled out part. Or from top if you tilt rear of part down. Pull assembly out. Remove solenoid and motor. 4 screws each. Motor just needed plastic scarps removed. Remove auger drive fork (left hand thread = turn to... Read more

We ordered the hooks for the shelf that had replaceable hooks. And we ordered the bottom shelf called "Pick off Shelf." The Pick off Shelf was just a replaceable shelf and was no problem. The shelf with the hooks wasn't as easy, but that's because we aren't very "savvy" when it comes to fixing things that come with no directions. The "friendly stories" that were at the bottom of each part that we ordered told the experiences of folks. That was very helpful. We persevered and fixed it. ... Read more

I received the parts from parts pro within 3 days and everything fit perfectly nd all went well Thanks Parts Pro Wayne Mazur Joliet Il Read more

Used a muiltimeter to test all parts and ohm'ed out all parts. found out condenser fan motor seized up [open winding in motor] replaced that, and found that also caused the compressor overload and relay to fail, from over heating and over cycling, replaced both parts, powered up the refrigerator retested all electrical parts checked amp reading on all parts under load conditions,works good know, hope to get another 15 years out of this refrigator, its a maytag. over 20 years old. Read more

Replaced the door flap...repair went very well. Read more

• Freezer section too warm
• Won't start

Thawed out the evap/heat exchanger assembly, replaced the overload/relay kit as well as the defrost control board and the fridge was back in business, everything working fine. I'm kicking myself for not ordering these parts earlier. there was a clicking sound coming from the compressor that I ignored which was a huge mistake. Read more

Appliances came with the house we recently purchased, but there were a few parts on the Jenn Aire refrigerator. It looked terrible! It was super-easy to locate the pieces I needed, but honestly I was not confident they would fit. But they did, and perfectly! My refrigerator looks brand new. If I ever need parts or to make a repair, this will be the first place I will turn. Thank you! Read more

• Fridge too cold

Replaced cold control Read more

Simply replaced the broken ice stripper with a new one. Read more

Upon receipt of part (in 2 days), removed right panel (snapped on). Removed ice tray. Removed one screw holding broken tray. Then removed plug from motor/solenoid. Next, moved motor/solenoid from old cracked tray to new one. All holes aligned exactly. Replaced shelf/motor in freezer, and reconnected cable from motor to freezer wall. Put one screw back in. Then replaced right-side snap-in panel. Finally, slid in ice-tray itself onto the new shelf. Tested okay. Read more